Traditional Comressed Air Energy Storage (CAES) is seen as one of the most cost effective technologies for the bulk energy storage in the future flexible grid. The project will investigate the
In this project, validated thermal models will be developed and used for a proposed condition monitoring method of wind turbine generators, using thermal imaging. The live thermal data will be
The project will evaluate the potential of reducing harm caused by emission from gas fired engine based CHP plants. This is done by combining measurements on engines at different engine setting with
This project seeks to demonstrate the methane reduction at gas engine CHP plants is possibel with technology previosly used on large dual fuel engines. Methane emission from gas engines raise the
The project focus on fuel cell based combined heat and power units as active elements for sourcing and sinking power to and from the SmartGrid on Bornholm. This is a pre-project to analyze the need
CATBOOSTER adresses the key bottlenecks for commercialization of PEMFC technologies: Performance, service life and cost. The project focuses on catalyst and electrode development and aims at a boost
The purpose of the project is improve the efficiency of Power Take off systems for Wave Energy Converters, by analysing and optimizing a new PTO-system with multiple pressure lines. This includes
The project aims to develop the communication technology based intelligent protection and post fault control methods for distribution systems. The developed protection and control methods would
This project will identify and analyze the primary causes for formation particles in exhaust gas from gas engines at CHP plants. The project will be performed in close co-operation with manufacturers
Based on the results achieved in Phase 1 and 2 (the practical experiments and theoretical calculations of a 5x5 m energy membrane), this project shall further clarify and assess the technical and
HI-CON A/S
ForskEL
2011
2011
As an initial step for FLOAT – a project on using UHPC for wave energy floaters - a study has been undertaken to investigate preliminary design of 2 types of floaters, essential properties of UHPFRC
The present application comprises co-funding of the IRD participation in the KeePEMAlive FC JTI project that presently is under negotiation for start primo 2010. The overall objective of the
The main objective of the DuRaPEM project is to further develop pathways and technologies for PEM FCs enabling the national target lifetimes to be met. The project approach is systematically to
The aim of the project is to evaluate and compare – technically and economically – options for using electricity storage to provide short term (seconds to an hour) system services at transmission
Development and demonstration of an intelligent remote control system for individual heat pumps, enabling the balance responsible party to plan consumption and deliver regulatory power, internal
The purpose of the project is to develop, design and demonstrate a total concept with solar heat, borehole storage and heat pump for electricity regulation and up to 100% reduction of fossil fuels on
The purpose of the project is to improve and validate newly developed models for simulation and prediction of wind power fluctuations, by integrating the tools with meteorological tools for wind
The main purpose of the project is the development of SO3 in-situ IR measurement technique which will be suitable for industrial applications on SCR units of power plants and proved on an industrial
Problem description: The impact of high penetration levels of PV has different dimensions: i) In the distribution network, a high share of PV may require new approaches for voltage control as the