A close collaboration between LM Wind Power and DTU aims to demonstrate a business case and map risks of new load alleviating blade technologies combined with multi-disciplinary optimization. A larger
Danish participation in IEA Wind Task 26 extension will enhance collaboration and understanding of cost trends in wind power, and contribute to knowledge dissemination on the cost aspects of wind
This project supports the Danish participation in IEA Wind Task 37 which aims to establish an international forum to catalyze the usage of systems engineering to design wind power plants, taking into
The project has generally the aim to support Denmark's participation in the "IEA Wind Energy R & D
Implementing Agreement" in 2016 through participation in the Agreement Steering Committee ("Executive
Denmark has since the 1. of January 2013 been a member of the IEA Heat Pump Program (HPP). DEA has designated Technological Institute to be representative of HPP's Executive Committee's work
The aim is within the International Energy Agency SHC Programme Task 54 project Price reduction of solar thermal systems to reduce the price of solar heating systems. This is achieved by use of
With the growing importance of integration of wind energy into power systems, the scope of Task 25 is proposed to be enhanced and broadened and to include collaboration with integration of solar
The purpose of the Danish participation in IEA PVPS work is to ensure Denmark receives the international knowledge which is fundamentally a continued Danish strategy within the field of photoviltaics
The DreamWind project is a collaboration between Vestas, Aarhus University and the Danish Technological Institute aiming at the development of novel recyclable composite materials for future wind
This project will develop a novel inspection and interpretation technology for performing in-situ measurements of leading edge surface roughness (LER) and convert these measurements into normative
The overall objective of the project is to demonstrate the system integration, the functioning, the performance and the value of an active flap system by full scale turbine tests. A further objective
The project objective is to drive the novel foundation, known as the Mono Bucket, to full commercial readiness and contribute significantly to reducing costs of offshore wind energy by 30-40%. This
The overall purpose of this project is to develop Medi Sander Wind and significantly reduce costs regarding blade production. The objective will be reached through a new patented technology. In
The objectives of the TrueWind project are to improve accuracy of cup anemometer measurements for wind resource assessment and power curve measurements by introduction of very short range lidar
FutureGas seeks to stimulate: an efficient and economical supply of gas - including gas based on renewable sources, an appropriate and flexible use of these gases, and an optimal integration of gas in
The target is to demonstrate the Floor as a structural enhancement technology on blades. This will overall reduce failure rates on blades and in the long run reduce the operation and maintenance cost