The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
Participation in ETDEs executive committee and ETDE's Technical Working Group. Within the IEA ETDE agreement a common database ETDE World Energy Base - ETDEWEB - is established. The database contains
The project is part of IEA-AMF annex 39 Part 2: Enhanced performance of Heavy Duty Methane Engines. The requested funding covers a supplementary test programme on gas fuelled buses and trucks, which
The project aims at cooperation between commercial and public sector partners to develop scenarios of the energy infrastructure in New City and Business Park in St. Rørbæk, Frederikssund Municipality
The objective is to disseminate information about Danish publicly funded R&D projects in
Denmark and internationally. This is achieved through the database DENP. With the creation of the
Danish energy
TORBEN SKØTT
EUDP
2012
2014
This project has to improve the communication between researchers and practicians, provide investors to projects, show which projects may be good business and finally point out technical subjects for
The overall objective of this IEA-task is to compile an extensive volume of information relative to the implementation of various alternative fuels within the European maritime sector and recommend
Participation of the Danish delegate to the international energy collaboration, to the annual meeting of the IEA-EOR Executive Committee. (International Energy Agency- Enhanced Oil Recovery).
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
The ''Smart Water'' injection strategy is based on laboratory experimental observations that variation of the injected water salinity and of its ion balance may result in large additional recovery
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
De Nationale Geologiske Undersøgelser for Danmark og Grønland
EUDP
2011
2014
The objective is to pave the way for a wider application in Denmark of heat pump systems based on closed loop boreholes - a technology with potential for CO2 reductions and energy efficiency. The
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure
Eco-friendly production of plastic solar cells in Denmark. Plastic solar cells are almost capable of competing with commercial solar cells. The processing method has environmental consequences in
Traditional Comressed Air Energy Storage (CAES) is seen as one of the most cost effective technologies for the bulk energy storage in the future flexible grid. The project will investigate the
The project will evaluate the potential of reducing harm caused by emission from gas fired engine based CHP plants. This is done by combining measurements on engines at different engine setting with
This project seeks to demonstrate the methane reduction at gas engine CHP plants is possibel with technology previosly used on large dual fuel engines. Methane emission from gas engines raise the