The aim of the project is to make detailed calculations of the necessary energy supply for heavy and light floor heating systems in buildings that conforms to the expected thermal requirements of the
Multi-openable glazed facade in a new multi-storey building. The purpose of this project was to demonstrate how new types of glazing and glazed areas can be incorporated in a new multi-storey building
New solutions have been developed for buildings with concrete panels without ribs at window reveals and at horizontal joints, corresponding to concrete panels with an unbroken insulation layer and
The project was carried out as a part of DK-SOFC 2000 - 20004. The DK-SOFC b line is targeted towards: 1) decrease of the operation temperature without increasing the area specific resistance, 2)
Lignocellulosic biomass is an abundant and renewable source of sugars that can be fermented into high value products like ethanol. Ethanol may be used as an octane booster, fuel extender or neat fuel
The objective of the project is to verify or falsify the recently published results claiming high hydrogen storage capacities of nanostuctured carbon materials, like for example single-walled carbon
The purpose of this research program is to support the long-term research and technology development to enable the use of the HTS technology in the years 2005-2010.
The main purpose of phase 3 was to prepare and present the results from the two first phases in a form that can be directly used by the consultant's in the future school-building activities.
A number of ash samples where collected at four Danish municipal solid waste incineration (MSWI) plants. Samples of bottom ash/slag, 2nd-3rd pass ashes and ESP/E-filter ash were collected at the
De Nationale Geologiske Undersøgelser for Danmark og Grønland
EFP
2001
2002
This study describes and correlates the palynology of the Cretaceous to Palaeogene succession from four selected wells offshore eastern Canada and six on- and offshore wells West Greenland. Twenty new
The main objectives are the following: a) development of a design tool for analysis of dynamic stability. b) investigations of blade tip aerodynamics and blade tip design on basis of 3D CFD
The overall purpose of the project has been to determine the safety aspects of getting wave load on offshore decks. This goal has been achieved by the main tasks: 1) Improved understanding of physical
This pre-project had the aim of establishing the basic technical knowledge to evaluate whether remote surveillance of the rotor blades of large off-shore wind turbines has technical and economical
Ice loading on wind turbine foundations is a design load in the inner Danish seas and straits. Relatively conservative design requirements/guidelines have so far been used for prediction of ice loads