This project wants to develop a serial of integrated design and environment strategies for the future office environment (New Ways of Working), where architectural, technological, decor and
A three-dimensional chemical mapping of active plastic PV cell layers has generated new knowledge of degradation causes for PV cells. Based on the mapping, more stable PV cells were made, which in
The project generated results in selected areas of flexible multibody wind turbine modelling. Monte Carlo statistical response simulations and failure probabilities require significantly reduced
In DTU's and LM Wind Power's wind tunnel, the project performed several measurements of the flow behind vortex generators (VG). The project proved that the induced vortices effectively counteract
The project highlighted markets and instruments aimed at promoting renewable energy in Denmark, the EU and internationally, while also identifying key risks and uncertainties related to renewable
The project will continue developing a computer model capable of predicting defect concentrations and distributions as a function of parameters during the float-zone process that produces silicon for
The project aimed to find new electrode materials for hydrogen development able to replace the costly and rare platinum normally used in PEM fuel cells. The project succeeded in demonstrating that
By setting up an experimental facility - SYSLAB – the project studied aspects of the basis for distributed resources such as wind turbines, photovoltaics and not least consumers participating in power
The project aimed substantially to strenghten the scientific basis for the wind turbine sector in general with particular focus on the Danish sector’s position in offshore wind farms. To meet these
Using catalysts, enzymes and bacterial cultures, the project uncovered promising methods for converting biomass into more valuable products such as fuels in the form of ethanol, methane and hydrogen
The feasibility of utilizing energy crops (willow and miscanthus) and agriculture residues (wheat straw and corn stalker) in an anaerobic digestion process for biogas production was evaluated
The project was conducted as a PhD study at the DTU in cooperation with Danish foundries and a supplier of foundry machinery. A thorough experimental analysis of the flow of melts in inlet systems was
The project developed and demonstrated an air-conditioning system based on dehumidification via a heat-driven, wet sorption process and adiabatic cooling. Calculations show that (district) heat-driven
To increase the interest for individual office lighting, the project developed a prototype of a more energy-efficient office lamp meeting the DS 700 requirements for illuminance. Both readings and