The objectives of this project is to improve on the current practice of basing performance evaluation on a single point measurement of wind speed and instead introduce a method where the wind field
This project has investigated noise emissions from large-scale wind turbines in relation to small-scale wind turbines. In addition, noise nuisance at low frequencies was investigated, noise
The aim of the project is to develop a simulation platform for generation of relevant wind fields applicable for aeroelastic design simulations. This is achieved by development, verification, and
The annex will give the participants an overview of the technical and environmental assessment challenges encountered in offshore applications and help them to understand the areas of further R and D
The wind farm output of an offshore-farm such as Horns Rev changes between nearly constant output to highly variable power output. A balance responsible would benefit from knowing the variability of a
The object of the project was to determine the wave impact on wind turbines and test ways to reduce such impacts. The project showed that all major wave loads are caused by breaking waves and that
The project developed a computer method for quantifying wind turbine structural loads caused by fault ride-through (FRT) requirements. Exemplified in the case of an active stall wind turbine this
The main goals of the simulation platform can be summarized as follows: 1) To extend the ability of the existing wind turbine design tools to simulate the dynamic behavior of the wind turbines and the
The objective of the project was an improved design base for extreme loads and fatigue loads on wind turbine in flat or mountainous terrain. The main activity was the development of models for non
The aim of the project is to develop better design basis for large wind turbine blade of composite materials by a combination of materials research, structural mechanics, involving both modelling and
The main objectives are the following: a) development of a design tool for analysis of dynamic stability. b) investigations of blade tip aerodynamics and blade tip design on basis of 3D CFD
This pre-project had the aim of establishing the basic technical knowledge to evaluate whether remote surveillance of the rotor blades of large off-shore wind turbines has technical and economical
Ice loading on wind turbine foundations is a design load in the inner Danish seas and straits. Relatively conservative design requirements/guidelines have so far been used for prediction of ice loads