This main objective of this project is to demonstrate procedures that can quantify the risk of failure, the remaining structural reliability and the maintenance costs upon extending the life of
IEA Wind Task 28” on Social Acceptance of Wind Energy Projects is a working group involving several countries, including the USA, Germany, Denmark, Switzerland, Japan, Ireland, Italy and the
Because these hours are incoherent and unpredictable, a constant availability of power is imperative and as a result the generator has to be operating around the clock. Thus Power Pack will contribute
A wind turbine power converter includes power modules mounted on cooling plates, which cool the component. The heat is transferred to the ambient by use of a water circuit and an air cooler. The
The project has generally the aim to support Denmark's participation in the "IEA Wind Energy R & D Implementing Agreement" in 2018 through participation as Alternate member in the Agreement Steering
The project will design and test innovative blade tips for wind turbines which can increase the existing rotor size, producing up to 8% more energy per year, while regulating loads in a smart way.
Every wind farm project requires accurate resource assessments to evaluate the energy yield and profitability, but for projects in hilly, mountainous or forested areas the measurement campaigns can be
Small cracks in wind turbine bearings are responsible for some of the most expensive wind turbine failures. Today, there are no certain methods of preventing the cracks, but a new project led by DTU
The main goals of the simulation platform can be summarized as follows: 1) To extend the ability of the existing wind turbine design tools to simulate the dynamic behavior of the wind turbines and the
The objective of the project was an improved design base for extreme loads and fatigue loads on wind turbine in flat or mountainous terrain. The main activity was the development of models for non
The aim of the project is to develop better design basis for large wind turbine blade of composite materials by a combination of materials research, structural mechanics, involving both modelling and
The main objectives are the following: a) development of a design tool for analysis of dynamic stability. b) investigations of blade tip aerodynamics and blade tip design on basis of 3D CFD
This pre-project had the aim of establishing the basic technical knowledge to evaluate whether remote surveillance of the rotor blades of large off-shore wind turbines has technical and economical
Ice loading on wind turbine foundations is a design load in the inner Danish seas and straits. Relatively conservative design requirements/guidelines have so far been used for prediction of ice loads