The objective of BLATIGUE-2 is to develop fast and efficient fatigue testing methods for large wind turbine blades, to develop smart equipment to excite the blades under such tests and to increase
The purpose of the project is to increase the liability of blades in operation by installing RTZ Solution. Further, the purpose is to reach higher cost efficiency and higher AEP for the wind turbine
Fatigue of fiber rope is crane applications is not well established, why extensive full-scale testing is currently required for using fiber ropes in crane applications. The main objective of this
LERCat enables leading edge roughness (LER) repairs of wind turbine blades at the right time, yielding a 1 bn DKK/year gain across the partners’ turbine fleets. This is achieved by establishing an
The project involves the development and maturement of a drone charging station and a drone system. The combined system should then be capable of conducting autonomous wind turbine inspections and
Managing offshore corrosion is a subject that is heavily regulated and combined with several industry standards that must be followed to ensure the structure integrity of the assets. Yet, whilst, and
The purpose of IDEA is to establish reference site conditions and wind reference wind farm designs for floating wind turbines. The project follows the international IEA project on wind farm design and
The overall objective of this project is to further adapt, improve and expand the existing operational tracking technology that Claviate has developed to cover the entire onshore wind turbine
We aim to demonstrate that a radically new blade technology combining jointed modular blades with advanced tips made with additive manufacturing can enable increased rotor sizes by up to 20% and lead
The objectives of this project is to improve on the current practice of basing performance evaluation on a single point measurement of wind speed and instead introduce a method where the wind field
This project has investigated noise emissions from large-scale wind turbines in relation to small-scale wind turbines. In addition, noise nuisance at low frequencies was investigated, noise
The aim of the project is to develop a simulation platform for generation of relevant wind fields applicable for aeroelastic design simulations. This is achieved by development, verification, and
The annex will give the participants an overview of the technical and environmental assessment challenges encountered in offshore applications and help them to understand the areas of further R and D
The wind farm output of an offshore-farm such as Horns Rev changes between nearly constant output to highly variable power output. A balance responsible would benefit from knowing the variability of a
The object of the project was to determine the wave impact on wind turbines and test ways to reduce such impacts. The project showed that all major wave loads are caused by breaking waves and that
The project developed a computer method for quantifying wind turbine structural loads caused by fault ride-through (FRT) requirements. Exemplified in the case of an active stall wind turbine this
The objective of the project was to participate in the IEA annex 'Dynamic models of wind farms for power system studies'. The objective of the IEA annex is to establish an international forum for
The main objective of Annex XVII is to provide wind energy planners and designers, as well as the international wind engineering community in general, with easy access to quality controlled measured