The main objective of this research project was to study the potential of reducing energy used for ventilating buildings by using low-polluting building materials.
The Stenløse South project is seen as a forerunner project by many (if not most) of the municipalities in Denmark and many of these has visited the site and the municiplaity or has invited
In accordance with the Danish national PV Strategy an investigation has been carried out to: 1) elucidate the connection - if any - between deployment of and prices for PV technology; 2) analyze the
The project developed dynamic simulation models for water-based building-integrated systems (e.g. floor heating, cooling ceilings and building-integrated cooling systems) and implemented them in the
The purpose of this project has been to extend the foundation module in HAWC and FLEX to be able to simulate the frequency dependent stiffness and damping of the foundations.
The project studied the transportation in a small scale pilot grid at the research centre in Hørsholm, Denmark. The test program included steel pipes from the Danish gas transmission grid and polymer
The main aim of the project has been to reduce the total energy consumption in two typical Danish typehouses to a level corresponding to the demands for low energy class 1 buildings in the building
The Project is a preliminary study of the possibilities for realization of 'Wind Power Academy' on Lolland. The vision of a Wind Power Academy was made as Energi E2 decided to establish a new park of
The overall objective of the project was to ensure the development of an aeroelastic design complex, which can create the basis for the next generation of wind turbines and make new design trends
The BRITA in PuBs project within the EU Eco-Buildings programme started in 2004 and finished in spring 2008. The project aimed to increase the market penetration of innovative and effective retrofit
The expression polygeneration is defined as the use of multiple primary energy inputs to create multiple en-ergy outputs. The aim of the project OPTIPOLYGEN is to investigate the potential of
The project objective was to optimise an LT PEM-based ìCHP and UPS system. Both IRD and Dantherm obtained significant project results. The project results regarding MEA performance, lifetime and stack
MEAs constitute the costliest key component and are also crucial to performance and lifetime of the total system. The project focused on developing basic materials and technologies for MEA improvement