The overall objective is to promote resilient low energy and low carbon cooling systems as the
mainstream and preferred solutions for cooling and overheating issues in the future energy
efficiency of
The aim of the project is:
- to increase the efficiency of both existing and new heat pump installations by developing a control kit that can optimize both the forward temperature from the heat pump
The purpose of this project is to ensure reliable international testing methods on electrical motor systems and frequency converters for the benefit of manufacturers, laboratories & MSA authorities
The purpose is to verify the influence of using gas phase air cleaning on indoor air quality, comfort, well-being, health and energy use, and to develop a test standard for gas phase air cleaners
The main purpose of IEA Annex 73 is to develop guidelines and tools that support the planning of Net Zero Energy Resilient Public Communities and that are easy to understand and execute. In order to
The project develops "iCeiling": A ventilation ceiling with hybrid ventilation (mechanical with heat recovery and natural ventilation), draft-free cooling and heating supplied by decentralized heat
The cost of offshore jacket foundations needs to be lowered to make this foundation concept competitive. The purpose of the project is to mature and develop a novel offshore jacket node concept, using
The purpose of the project is to reduce fuel consumption and thereby Co2 emissions in agriculture for straw transport. The goal is achieved by developing a system for automatic loading of tarpaulin
The purpose of the project is to strengthen the numerical modelling ability of the HAWC2 model
within 1) long-period motion from nonlinear waves 2) damping from soil 3) aerodynamics for
turbines with
Denmark has since the 1. of January 2013 been a member of the IEA Heat Pump Programme (HPP). DEA has designated Technological Institute to be representative of HPP's Executive Committee's work.
The goal of this project is to perform a trial installation of a full-scale prototype of a suction bucket for wind turbine jacket foundations. The installation is performed at an offshore site near
Standardization work with the aim to find common standards for: Inductive charging is a new method for charging EV,s. There´s no commercial available products. Thereis a need for standardization. V2G
Reduction of the cost for installaion of WTG towers with 50% at the same time supporting installation for even larger WTG and tower sizes in the future