Find Projects on our website via the search function on this page.
Displays 21 - 40 of 299
LEANCON Wave Energy
ForskVE
2012
2016
This ForskEL project will document the energy production of the wave energy converter MAWEC in real production mode. The overall project description is the same as in PSO project "Advanced Wave Energy
The purpose of the project is to design, build and test a 2 kW wave energy grid connected Lever Operated Pivoting Float LOPF buoy in the sea. The goal is to collect operational data on electric
RESEN ENERGY ApS
ForskEL
2011
2012
Wave energy, Lever Operated Pivoting Float LOPF, study of new taut moored buoy concept with direct electrical output. It will cover: Basic static theoretical optimisation of LOPF concept, design of
Traditional Comressed Air Energy Storage (CAES) is seen as one of the most cost effective technologies for the bulk energy storage in the future flexible grid. The project will investigate the
The project will evaluate the potential of reducing harm caused by emission from gas fired engine based CHP plants. This is done by combining measurements on engines at different engine setting with
This project seeks to demonstrate the methane reduction at gas engine CHP plants is possibel with technology previosly used on large dual fuel engines. Methane emission from gas engines raise the
The purpose of the project is improve the efficiency of Power Take off systems for Wave Energy Converters, by analysing and optimizing a new PTO-system with multiple pressure lines. This includes
This project will identify and analyze the primary causes for formation particles in exhaust gas from gas engines at CHP plants. The project will be performed in close co-operation with manufacturers
Based on the results achieved in Phase 1 and 2 (the practical experiments and theoretical calculations of a 5x5 m energy membrane), this project shall further clarify and assess the technical and
HI-CON A/S
ForskEL
2011
2011
As an initial step for FLOAT – a project on using UHPC for wave energy floaters - a study has been undertaken to investigate preliminary design of 2 types of floaters, essential properties of UHPFRC
Establishment of a data base of O&M data for Wave Dragon established in Nissum Bredning. Large uncertainty exists about fatigue impact on single components used in a wave device caused by repeated
Waveenergyfyn v/ Henning Pilgaard
ForskEL
2010
2011
Use the link Edit/view Data Sheet to edit project description
DEXA1:5 is a development project which aims to use an innovative, simple and flexible technology to validate wave energy as a cost-effective, competitive source of electrical power. Activities defined
The objective of the project is to make a 24 m long 1:10 scale version of a Leancon wave power machine that uses airflows created by a wave moving up and down a tube. The project is based on a
The project aims at optimising Wave Star wave machine production from irregular waves through sophisticated control of the back pressure in the hydraulic system in each floater. The system is being
The project is to investigate oxy-combustion of natural gas via advanced modeling. The main contents are: (1) to develop new models for gaseous radiative properties applicable to oxy-fuel combustion;
Grid connection and electricity production optimisation from a 500 kW Wave Star wave power unit located at Horns Rev. The project is closely linked to project 10239. If the project achieves the
The project is based on a previously tested 1:40 model of a new type of wave energy converter, which has so far shown good properties. The objective of the project is to measure loads on the