This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure
The aim of the project is to make a final energy optimization of an air staged downdraft gasification plant by measures that reduce the output of charcoal and the consequently energy loss from the
Objectives: a) to address the problems related to balancing power in a system with a substantial part of fluctuating renewable power sources and b) to develop planning methods and operational
Developing of ChoosCOM for intelligent charging and communication with electric cars and is test it by 2400 families in 300 EVs. Main investigation is whether it is possible to move the charge of EVs
The target of the proposed project is to study how to integrate large amount of Renewable Energy Sources (RES) into the network, without having to reinforce the network. This is done by examining
The proposed pilot project will analyse the need for and potential of a marina power distribution hub with smart-grid functionality for the expected increasing share of electrical tour- and pleasure
Traditional Comressed Air Energy Storage (CAES) is seen as one of the most cost effective technologies for the bulk energy storage in the future flexible grid. The project will investigate the
In this project, validated thermal models will be developed and used for a proposed condition monitoring method of wind turbine generators, using thermal imaging. The live thermal data will be
The project will evaluate the potential of reducing harm caused by emission from gas fired engine based CHP plants. This is done by combining measurements on engines at different engine setting with
This project seeks to demonstrate the methane reduction at gas engine CHP plants is possibel with technology previosly used on large dual fuel engines. Methane emission from gas engines raise the
The project focus on fuel cell based combined heat and power units as active elements for sourcing and sinking power to and from the SmartGrid on Bornholm. This is a pre-project to analyze the need
CATBOOSTER adresses the key bottlenecks for commercialization of PEMFC technologies: Performance, service life and cost. The project focuses on catalyst and electrode development and aims at a boost
The purpose of the project is improve the efficiency of Power Take off systems for Wave Energy Converters, by analysing and optimizing a new PTO-system with multiple pressure lines. This includes
The project aims to develop the communication technology based intelligent protection and post fault control methods for distribution systems. The developed protection and control methods would
This project will identify and analyze the primary causes for formation particles in exhaust gas from gas engines at CHP plants. The project will be performed in close co-operation with manufacturers
Based on the results achieved in Phase 1 and 2 (the practical experiments and theoretical calculations of a 5x5 m energy membrane), this project shall further clarify and assess the technical and
HI-CON A/S
ForskEL
2011
2011
As an initial step for FLOAT – a project on using UHPC for wave energy floaters - a study has been undertaken to investigate preliminary design of 2 types of floaters, essential properties of UHPFRC