The IDE4L project will define, develop and demonstrate the entire system of distribution network automation, IT systems and applications for active network management. The IDE4L-DK Top-Up project is
Power-to-gas (“P2G”) is an innovative and disruptive energy storage solution ideally suited for the Danish energy system. The P2G-BioCat Project is led by a consortium of highly qualified
An increasing amount of power electronic based units in electric power grids give rise to protection and control difficulties during disturbances. A solution is to install synchronous condensers
This project will conduct experimental research in order to identify the potential of a novel energy storage technology. The concerned technology is based on heat accumulation, in the phase transition
The SmartMEA project aims to develop the next generation high temperature PEM electrodes for improved durability and performance working under SmartGrid conditions. Focus is on electrode optimization
To fulfill the Danish Government's ambitious plan regarding renewable energy, some technical and economical hurdles have to be cleared. A major issue is energy storage. This project will present
The purpose of the project is to analyse and develop advanced filter solutions based on combinations of passive filters and active filters in wind power plants. The use of passive filters is almost
The project will result in recommendations for integration of heat pumps in existing distribution grid, which otherwise risk to be overloaded. The recommendations will be based on analysis of
In order to efficiently provide system services to the distribution grid, aggregators of flexible DER units require information about the topology of the grid. This information is currently not
Solid oxide fuel cells (SOFCs) are an energy conversion technology that can play a key role during the transition to 100% renewable energy in Denmark. This project aims to enhance the lifetime of
The object of the PROSOFC project is to increase the robustness of the solid oxide fuel cell technology, as this is a key challenge for bringing the technology to the consumers. To achieve this we
The purpose is to develop and validate a full set of industry relevant test procedures for solid oxide cells, addressing performance, durability and degradation. The project will develop test
The Introduction of a new supplemental power generation product based on fuel cells and methanol the current diesel genset will be replaced in telecommunications application in regions with poor or no
The objective of the REST project is to address the current limitations on reliability estimation and testing across several application segments for hydrogen and fuel cell technologies – with focus
The project ” Multi-level medium voltage” converter is a development and demonstration project, which by proposing at new design aims at optimizing one of the most important subsystems in a wind
The project will analyze the role of distributed energy storages in future energy systems. The goal is a more economical efficient integration of renewable energy. The project secures Danish
The aim of the project is to carry out a 360 degree feasibility study of a value chain for local production of liquefied bio gas to provide both the Samsø ferries and vehicles on land with fossil free
To learn how to build the hybrid UHPC tower in praxis and prepare the technology for commercialization. Further development to up-scale the towers to larger heights, to make the towers entirely from
Task 35 will focus on wind turbine blade and drive train testing and assess their performance and failure criteria in different operating scenarios. The subtasks are: l) Relevant wind turbine
Our objective is to demonstrate an efficient, rugged, low-cost lidar for wind turbine blade pitch control. The new sensor will monitor the wind in front of the turbine using 4 lines-of-sight. This