The purpose of the project was to create 3 architectural well functioning PV retrofit low-cost solutions. This was done in collaboration with well-known and estimated architect firms and Danish
The main points of the project are: 1) Improved methods for modelling of vertical and horizontal variation of wind speeds. 2) Verification, calibration and improvement of acoustic sensors for remote
The object of the research-project is to select which methods will give the best simulation of environmental influence in relation to the geographical placing of the mills, to be able to select what
The project, 'Transparent PV modules - shading devices of the future' is based on the vision of a shading device which is energy producing, sun shading and transparent. This solar cell can be achieved
The project concerns the modelling of aerodynamically generated sound from wind turbines with the aim of predicting and reducing noise emission from wind turbines.
Organic solar cells hold promise as a sustainable energy source and for energy cost reduction. They represent a cost-efficient alternative to silicon-based cells. However, current technologies still
Background: Planning wind farms offshore are generally based on little knowledge of the wind speeds. It is due to the limited amount of offshore meteorological observations worldwide. This again has
The main goals of the simulation platform can be summarized as follows: 1) To extend the ability of the existing wind turbine design tools to simulate the dynamic behavior of the wind turbines and the
The objective of the project was an improved design base for extreme loads and fatigue loads on wind turbine in flat or mountainous terrain. The main activity was the development of models for non
The aim of the project is to develop better design basis for large wind turbine blade of composite materials by a combination of materials research, structural mechanics, involving both modelling and
The main objectives are the following: a) development of a design tool for analysis of dynamic stability. b) investigations of blade tip aerodynamics and blade tip design on basis of 3D CFD