The main goals of the simulation platform can be summarized as follows: 1) To extend the ability of the existing wind turbine design tools to simulate the dynamic behavior of the wind turbines and the
The objective of the project was an improved design base for extreme loads and fatigue loads on wind turbine in flat or mountainous terrain. The main activity was the development of models for non
The aim of the project is to develop better design basis for large wind turbine blade of composite materials by a combination of materials research, structural mechanics, involving both modelling and
The main objectives are the following: a) development of a design tool for analysis of dynamic stability. b) investigations of blade tip aerodynamics and blade tip design on basis of 3D CFD
This pre-project had the aim of establishing the basic technical knowledge to evaluate whether remote surveillance of the rotor blades of large off-shore wind turbines has technical and economical
Ice loading on wind turbine foundations is a design load in the inner Danish seas and straits. Relatively conservative design requirements/guidelines have so far been used for prediction of ice loads
The activities in 1996 has to a large degree followed the budget proposal of 27 June 1995. During the year two IEA Executive Committee meeting were held, first in Finland and then in Germany. The
Nordtank Energy Group A/S. Udvikling og Konstruktion
EFP
1996
1997
The key target for the proposal is - by combining the latest technology related to generators and power electronics with the latest in wind turbines - to develop a new generation of grid-connected
This project will focus on the possibilities for achieving higher power production, less mechanical stress and a greater degree of flexibility by using both pitch and variable speed control in
A status has been performed within the research area 'Aeroelasticity for Wind Turbines', and on this basis, demands for research and perspectives for a future effort are identified.
The objective is to analyse and describe the edgewise vibrations, which have been observed during stalled operation on Danish and foreign 19 m wind turbine blades, and further to improve the models
A study has been performed, which investigated the possible application of Doppler laser anemometry for performance assessment and control of wind turbines.
It is the aim of the project: 1) To supplement the existing offshore wind data base, by setting up offshore meteorological measurements significantly further away from the coast than previously and