ElectroGas develops knowledge and technology which can take surplus electricity from renewable energy and use it to upgrade CO2 to CH4 by feeding it to microorganisms present in biogas reactors.
The researchers of LEDSiC is exploring how wavelength conversion using fluorescent silicon carbide can produce white light-emitting diodes (LEDs). LEDs looks to be the market leading light source of
The researchers of e-STORE seeks to improve our ability to store energy by using power-to-gas technology.
Danmarks Tekniske Universitet (DTU)
Innovationsfonden
2015
2019
Along with engine designers Danish and international researchers are looking to adress and explain how sulfuric acid forms and condensates in ship engines. The problem with "cold corrosion" caused by
SYNFERON aims at establishing a new technology platform that combines thermochemical and biological processing of biomass in order to make the production of biogas easier.
Air traffic will be dependent on liqued fuels in all foreseeable future. The goal of FLABBERGAST is to develop an environmentally sustainable production of bioethanol that also fulfills the physical
The foundation for wind turbines at sea needs to withstand occational extreme waves. Extreme waves are a well known phenomenon, however the exact stress they put on under water foundations are not
The objective of this project is to develop and demonstrate a 10 MW pressurized entrained flow gasiflcation technology that can utilize low quality biomasses in the energy sector in an efficient and
We will optimize stalk as a biomass. By pregrinding the stalk, we can reduce the residence time in the biogas reactor. The particle size of 05-15 mm. will be much easier to organically convert, and we
As different renewable energy sources, like sun, wind and biomass, become more widespread as energy sources in the different energy grids in urban areas, the aim of the project is to investigate how
The purpose of the project is to develop LED lighting solution for EX areas that comply with the requirements for the EX standards concerning protection against explosive gas atmospheres, combustible
Standardization work with the aim to find common standards for: Inductive charging is a new method for charging EV,s. There´s no commercial available products. Thereis a need for standardization. V2G
The purpose is to develop and demonstrate a new efficient and flexible technology for fault localization/-diagnosis in PV systems. The technology is aimed the growing PV service market. Measurements
Heliac has invented and patented a foil that enables a reduction installation costs of solar fields from 500$⁄m2 to 2- 10$⁄m2 and reduce the overall cost by 80%. Proof-of-concept in lab scale was
The aim of the project is to participate in IEA Hydrogen Implementing Agreement (HIA), in order to stimulate hydrogen R&D activities in Denmark and to co-ordinate Danish and international scientific
The project objective is to test, verify and document the radar control installation aiming at defining the minimum requirements for this type of system capability. The project will also investigate
The project will demonstrate that solar energy modules can transform an old multistory residential building into a beautiful self- sufficient architectural building getting free renewable electrical
The objective of the project is on basis of participation in the IEA Task 29 MeXNext III to utilize the results from a new wind tunnel measurement campaign on a 4.5m rotor (summer 2014) for validation