RETROMAX aims to develop and demonstrate a slurry treatment technology that economically increases the amount of animal slurry/manure based feedstock to biogas plants resulting in a higher biogas
The project aims at testing the Pyroneer technology as a promising platform for improved utilization of a variety of low-value and difficult fuels from different sectors in society in order to produce
Topsoe's new methanol reactor (CONRAD) produces syngas and methanol from biomass. The project will demonstrate that CONRAD works as expected at industrial conditions and investigate how this novel
The purpose of the project is to create a sustainable systemic energy concept based on local CO2 neutral energy sources by integrating biomass based technologies and optimizing the energy flows
The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
The aim of lEA Bioenergy Task 37 is the international collaboration and mutual exchange of research, knowledge and information between the member countries, in the area of production and utilisation
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
The objective is to develop a system that permits a diesel engine to run on bio-ethanol with high efficiency and low emissions. R&D in system components, catalyst as well as fuel injection and engine
The project develops and demonstrates a new biogas infrastructure consisting of 35 km biogas grid, connectiong 5 farm biogas plants with Skjern Power Supply. This is the first stage in ''Ringkøbing
ComBigaS will develop a biogas plant where the slurry is being produced so the flow of energy is being minimized. The systems are developed with an eye to the standardization and thus facilitate makes
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
The project will demonstrate how cereal straw is effectively pretreated and co-digested with animal manures in large biogas plants. . The technology is based on mechanical compression and hydrolysis
The objective of the project was to improve the use of animal manure for biogas production by a thermo-alcalic hydrolytic pre-treatment. Substantial gas yield improvements have been documented for all
This project will demonstrate erection and operation of an entire biomass gasification plant for CHP production in the commercial size of 1,300 kWth. In the project a complete commercial size forest
The aim of this project is to develop a wood stove with high energy efficiency and low emissions of pollutants and CO2. We will develop a generic control system for wood stoves and an optimized