The project objective was to undertake a screening of commercial natural gas reformers to be used in combi-nation with low temperature PEM fuel cells in the power range 2-3 kWe.
The purpose of the project is to further develop a Danish natural gas reformer system including optimisation of subsystems and the overall system consisting of a natural gas reformer and fuel cell CHP
The project built on the results of a 2001 hydrogen project which focused on hydrogen as an energy carrier in a purely Danish system. The perspectives of this project were extended to include the
The project was focused on the development of new design methods for wind turbine blades, so that uncertainties associated with damage and defects can be reduced.
The overall aim of the project was to determine what effect the energy policy introduced through the law on CO2-quotas would have on the development the energy sector in Denmark.
The aim is to make information about Danish energy research and its results available to users in Denmark and abroad and, through international co-operation, to make international research and its
The aim of the project is to elaborate and disseminate knowledge about the development of the heat supply of residential areas in the future in terms of the changed conditions.
The study contaiins a review of the current sorption gas fired heat pumps for residential space heating and also the visible development trends. A prototypw heat pump has been laboratory tested.
The project studied the transportation in a small scale pilot grid at the research centre in Hørsholm, Denmark. The test program included steel pipes from the Danish gas transmission grid and polymer
The overall objective of the project was to ensure the development of an aeroelastic design complex, which can create the basis for the next generation of wind turbines and make new design trends
The project objective was to optimise an LT PEM-based ìCHP and UPS system. Both IRD and Dantherm obtained significant project results. The project results regarding MEA performance, lifetime and stack
MEAs constitute the costliest key component and are also crucial to performance and lifetime of the total system. The project focused on developing basic materials and technologies for MEA improvement
The project evaluated the benefit of compressed air energy storage (CAES) in a Danish system, where wind power accounts for 20% of consumption and CHP for 50%. The project starting point was energy
One of the main results in this project is the breakthrough in the development of 2.5G cells, which are now leading in terms of performance and stability. Moreover, increased understanding of the
Methanol and ammonia based on biomass may become highly attractive in a future hydrogen system. Methanol can be produced from biomass with total efficiency of 50%. The same number cannot be reached