A concept for energy efficient control of air-air heat pumps and electric storage water heaters with focus on indoor clima, energy savings and demand response is developed. A plug n' play-solution for
The purpose of the project is to identify limitations of existing simulation and planning tools for distribution grids, with a particular focus on the challenges imposed by the introduction of Smart
The goal of the project is to increase the efficiency and reduce emissions for engines operating on biogas and biomass producer gas. Engine operation will be characterised experimentally and
IHSMAG studies the integration of households in the smart grid and develops design recommendations. The Danish part focuses on how electric vehicles are integrated into the everyday life of households
The aim for the proposed project is to analyze and demonstrate the possibilities of utilizing environmental-friendly surplus power production for heat production. Developing and demonstration of the
The project will result in a concept for the information needed, when power consumers are to participate more actively in the power market by making their consumption flexible in time and dependent on
Objectives: a) to address the problems related to balancing power in a system with a substantial part of fluctuating renewable power sources and b) to develop planning methods and operational
Developing of ChoosCOM for intelligent charging and communication with electric cars and is test it by 2400 families in 300 EVs. Main investigation is whether it is possible to move the charge of EVs
The target of the proposed project is to study how to integrate large amount of Renewable Energy Sources (RES) into the network, without having to reinforce the network. This is done by examining
The proposed pilot project will analyse the need for and potential of a marina power distribution hub with smart-grid functionality for the expected increasing share of electrical tour- and pleasure
Traditional Comressed Air Energy Storage (CAES) is seen as one of the most cost effective technologies for the bulk energy storage in the future flexible grid. The project will investigate the
The project will evaluate the potential of reducing harm caused by emission from gas fired engine based CHP plants. This is done by combining measurements on engines at different engine setting with
This project seeks to demonstrate the methane reduction at gas engine CHP plants is possibel with technology previosly used on large dual fuel engines. Methane emission from gas engines raise the
The project aims to develop the communication technology based intelligent protection and post fault control methods for distribution systems. The developed protection and control methods would
This project will identify and analyze the primary causes for formation particles in exhaust gas from gas engines at CHP plants. The project will be performed in close co-operation with manufacturers
Based on the results achieved in Phase 1 and 2 (the practical experiments and theoretical calculations of a 5x5 m energy membrane), this project shall further clarify and assess the technical and