The purpose of the project is to fully implement an off-grid renewable energy solution for Livø Island. A previous project has - based on e.g. the amount of local energy sources from agriculture and
The IDE4L project will define, develop and demonstrate the entire system of distribution network automation, IT systems and applications for active network management. The IDE4L-DK Top-Up project is
An increasing amount of power electronic based units in electric power grids give rise to protection and control difficulties during disturbances. A solution is to install synchronous condensers
This project will conduct experimental research in order to identify the potential of a novel energy storage technology. The concerned technology is based on heat accumulation, in the phase transition
Biomass Gasification Polygeneration (BGP) - A highly efficient BGP system is developed to mitigate the problems related to a high penetration of electricity from fluctuating, renewable sources. The
It is possible to reduce the Cost of Energy from Wave Energy Converters by utilizing Digital Hydraulic Power Take Off. The project aims at solving the main technical hindrance for enabling wave energy
The Danish energy system will increasingly demand flexible power production. CHP from biogas may be regulated by the application of easily digestible and concentrated biomass types. This project
The main objective of this project is to establish the optimal operation criteria for high efficiency and stability of manure co-digestion processes. The optimisation of substrate mixing and feeding
The project is part of the development of a tradition of cooperation for further development of wave energy, here, through the implementation of an exemplary development process. The project contains
The objective of the project is to develop a gyro electric converter unit for wave energy, and to test experimentally a 5 kW unit under realistic conditions.
To finish development and provide proof of concept for a technology, which makes it possible to separate unseparated household waste in 5-7 fractions in one separation step, one fraction is
LED lighting includes a huge potential for energy saving. Substantial variation in quality for LED sources might destroy consumer confidence and delay the market penetration. In 2010, an IEA co
Light Extraction improves the efficiency of LED. Our method is based on industrially reproducible nanostructures that are more efficient than the microsized structures the industry uses today. The
The aim of the project is to develop an efficient and economical solution for cleaning of smoke from biomass fried boilers. Focus will be on straw, but also other biofuel types will be tested. There
D-Light will develop light sources based on diode lasers and demonstrate application of these light sources in lamp posts. Light sources based on diode lasers have the potential of being significantly
He project aims to develop and demonstrate new corrosion resistant coating materials for heat Exchangers (superheaters) in biomass fried CHP plants. These materials can improve the economy in biomass
The project objective is to investigate the economical, practical and environmental properties of using alternative fuels in a Dall Energy multifuel furnace, and to investigate if the nutrients in the
The purpose is to develop and validate a full set of industry relevant test procedures for solid oxide cells, addressing performance, durability and degradation. The project will develop test
The Introduction of a new supplemental power generation product based on fuel cells and methanol the current diesel genset will be replaced in telecommunications application in regions with poor or no