The project is testing a new type of IoT sensor technology. Today, the individual IoT sensor must be connected to power or contain batteries. New technology based on induction, makes it possible to
Investigation of the potential for optimized and reduced energy consumption via improved installation, monitoring and continuous adjustment of heat pumps in Danish homes, using IoT enabled machine
Plastic production is an energy intensive process with a high heating and cooling demand. The project will convert direct electricity use to an integrated solution, where the supplied energy is
In the project, a self-learning predictive control is developed and demonstrated that can de-liver the best possible indoor climate at minimal energy consumption. This is achieved with a digital twin
An intelligent adaptive control is being developed for heat pump-driven decentralized ventilation systems. This type of system is gaining ground on the basis of a sustainability criterion, as the
Disinfection with ultraviolet (UV) radiation is an effective but energy consuming way to control the corona pandemic. New UV-LED technology enables new applications of UV-light with potential energy
International lighting standards set important conditions when it comes to saving energy on
lighting. The project will incorporate greater attention to energy savings combined with lighting
quality in
The aim is to develop an electrified fast process for continuous heat treatment of solid foods using ohmic heating. The process is very energy efficient as the energy loss is only around 5%. In
The project shall uncover and realize potentials for energy savings on ventilation systems in public buildings using artificial intelligence on data concerning energy usage, indoor environment
In industry, despite previous efforts, there is still a large realizable potential for energy savings. With the project's developed IT software package, energy audit consultants and energy man-agers
This project focuses on synchronous re-luctance motors, and the frequency converters based on the WBG technology which both will increase the efficiency of the motor systems. The technologies are
The idea is to develop a method that makes Be10 a tool that can be used to identify energy offenders i low-energy building and contribute to securering that low-energy building actual performes as low
The project aim is to create the conditions to achieve energy savings of almost 286 GWh per year equalling around 50 % of the total energy consumption off drying-out Danish building sites.
In cooperation with a supplier of energy plants we are going to examine in practice, a combination of a heat pump and a condensing gas-fired boiler in a boiler room that provides central-heating to a
The project aim is to determine requirements and preconditions for a two-pipe chilled beam system for cooling and heating that also can procure a thermally indoor climate at the same level as with a
The project develops a simple, low-cost, installation and service friendly energy efficient air heating system that covers the need for ventilation, heating and hot utility water by combining