The goal has been to further develop and test simple models of district heating systems for simulation and operational optimisation, and to investigate the significance of the load distribution (both
Recent years have witnessed a wide range of energy saving measures in Denmark, which have decreased the unit heat consumption by district heating consumers dramatically. The geometrical density of new
The project was carried out as a part of DK-SOFC 2000 - 20004. The DK-SOFC b line is targeted towards: 1) decrease of the operation temperature without increasing the area specific resistance, 2)
The objective of the project is to verify or falsify the recently published results claiming high hydrogen storage capacities of nanostuctured carbon materials, like for example single-walled carbon
Goal: To demonstrate the performance of a fuel cell bus in Copenhagen. Programme/Plan: When the bus is constructed, it will go into service in Berlin and then Copenhagen.
A 20 Nm2 Hydrogen storage has been specified to be used in a Ford Focus equipped with an internal combustion engine. The storage is constructed from commercial available metal hydrides.
The objectives of the project were to develop and manufacture a lightweight storage for hydrogen usable for pressures up to 300 bar and based on fibre reinforced tanks. Three storages have been
The objectives of the project have been to design and construct a PEM fuel cell driven car, which can be used for demonstration of hydrogen as a fuel in the transport sector. The project has been
The project is divided into two parts, i.e. a general review part and a project specific part. General: 1) General review of safety aspects related to hydrogen driven vehicles and related stationary
The aim of the project is to analyse energy, environmental and economic aspects of integrating electric vehicles in the future Danish energy system. Consequences of large-scale utilisaltion of
The project's superior objective is to work as a catalyst for distribution and practical use of a number of optimization methods and tools for the district heating sector. By collecting these
A method has been established for production of the anode supported thin-electrolyte cell. The anode supportis 200mum thick and made of NiO and TZ3Y by tapecasting. The electrochemically active anode
The main purpose of the present project has been to test a new type of MCFC unit developed in previous phases of the project. Various parts of the plant e.g. MCFC stack, reformer, catalytic burner