The project will demonstrate the eSmr-MeOH technology in an industrial relevant siza to enable commercialization after the project. Combined with techno economic evaluations, this will elucidate how
The goal of 3R is to develop an efficient process for environmentally friendly recovery of precious metals to make them available for reuse in fuel cells and electrolysers, which will be in great
The purpose of the project is to demonstrate how energy production from offshore wind can be utilized to produce renewable hydrogen through electrolysis in an integrated system, where the hydrogen
Decarbonization of the maritime sector is a political topic shaping regulations and restrictions for vessel emissions at sea and in ports. The political initiatives focus on CO2, SOx, NOx and particle
Goal: To demonstrate the performance of a fuel cell bus in Copenhagen. Programme/Plan: When the bus is constructed, it will go into service in Berlin and then Copenhagen.
A 20 Nm2 Hydrogen storage has been specified to be used in a Ford Focus equipped with an internal combustion engine. The storage is constructed from commercial available metal hydrides.
The objectives of the project were to develop and manufacture a lightweight storage for hydrogen usable for pressures up to 300 bar and based on fibre reinforced tanks. Three storages have been
The objectives of the project have been to design and construct a PEM fuel cell driven car, which can be used for demonstration of hydrogen as a fuel in the transport sector. The project has been
The project is divided into two parts, i.e. a general review part and a project specific part. General: 1) General review of safety aspects related to hydrogen driven vehicles and related stationary
A method has been established for production of the anode supported thin-electrolyte cell. The anode supportis 200mum thick and made of NiO and TZ3Y by tapecasting. The electrochemically active anode
The main purpose of the present project has been to test a new type of MCFC unit developed in previous phases of the project. Various parts of the plant e.g. MCFC stack, reformer, catalytic burner