The objective of the project was to participate in the IEA annex 'Dynamic models of wind farms for power system studies'. The objective of the IEA annex is to establish an international forum for
The main objective of Annex XVII is to provide wind energy planners and designers, as well as the international wind engineering community in general, with easy access to quality controlled measured
The main objective of the project is to implement controller design of wind turbines in the general design process, on the same level as structural dynamics and aerodynamics. Specific focus is on
Background: Within the Aeroelastic Research Program carried out from 1997 to 2002 by Risø and DTU a coordinated and continuous work has been carried out on the development of advanced computer models
The main goals of the simulation platform can be summarized as follows: 1) To extend the ability of the existing wind turbine design tools to simulate the dynamic behavior of the wind turbines and the
The objective of the project was an improved design base for extreme loads and fatigue loads on wind turbine in flat or mountainous terrain. The main activity was the development of models for non
The aim of the project is to develop better design basis for large wind turbine blade of composite materials by a combination of materials research, structural mechanics, involving both modelling and
The main objectives are the following: a) development of a design tool for analysis of dynamic stability. b) investigations of blade tip aerodynamics and blade tip design on basis of 3D CFD
This pre-project had the aim of establishing the basic technical knowledge to evaluate whether remote surveillance of the rotor blades of large off-shore wind turbines has technical and economical
Ice loading on wind turbine foundations is a design load in the inner Danish seas and straits. Relatively conservative design requirements/guidelines have so far been used for prediction of ice loads