The aim of the project is to innovative refine an own financed CSP prototype system to a stage of commercialization, and to demonstrate the technological, economic and environmental advancement, which
Silicon is today the most used photovoltaic material for solar cells, yet they are complicated and expensive to make. Different composition and micro structures for thin film solar cells made from the
The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
Eco-friendly production of plastic solar cells in Denmark. Plastic solar cells are almost capable of competing with commercial solar cells. The processing method has environmental consequences in
We will develop a complete residential PV system for grid connection, all in one 230 V AC, 50 Hz, 270-350 W module, with substantial testing to realize a system with the required performance of more
The objective of this project was to initiate a new IEA-SHC task for large scale solar heating systems. The aim of the task is to exchange experiences concerning large scale solar heating systems and
Danish lead in new IEA-SHC task for large solar heating systems. - Optimise large scale solar heating systems - focus on design and operation of combined systems including heat pumps and seasonal
The project shall demonstrate a heat pump seasonal storage connected to the upcoming 35.000 m2 solar plant in relation to Donninglund Fjernvarme. EUDP has in 2009 granted 12. mio. kr. to the project
The main objective is to enable the Danish participation in a newly started project within the framework of the IEA-SHC programme (solar heating and cooling). The title of the new task is Task 44
The project Energy efficient prefab. facade- and roof element has as purpose to design, develop and demonstrate an cost effective building element with integrated photovoltaic through the use of pre
Photovoltaic technology has a huge potential in a renewable energy system. Today, however, solar cells are expensive and not very efficient. THINC seeks to develop a new type of solar cells, using