The project is a joint European project, the main objective of the Gasification Guide project being to accelerate the market penetration for small-scale biomass gasification systems ( 5 MW fuel power)
This project is the first phase of a project consisting of three phases, which aims at demonstrating micro CHP based on Danish fuel cells. The project will test three different fuel cell technologies
The project has shown that there is potential for particularly demand response energy consumption within the industry. If businesses offer this potential on markets it is required that the payment is
Danish greenhouses have a relatively high level of electricity consumption for grow light. Part of the electricity consumption is flexible, and the main purpose of the project was to find out if the
The object of the project was to determine the wave impact on wind turbines and test ways to reduce such impacts. The project showed that all major wave loads are caused by breaking waves and that
The Integrated Biomass Utilisation System (IBUS) is a new process for refining lignocellulosic waste biomass. The process is energy-efficient due to very high dry matter content in all process steps
It is a common opinion that water electrolysis is an available and mature technology, which is not wide spread because it is too expensive compared to steam reforming of hydro carbons. As a
A report was completed in summer 2007. The report was successfully presented at the PREHEAT seminar, which took place at the Intersolar exhibition in Freiburg, June 21-22 2007. A PowerPoint
More than 500 households with electric heating participated in a demonstration project about demand response. Participants paid for electricity based on spot prices. The groups notified of the next
Contact-free, fast optic measurements of NO and other gas concentrations at high temperatures in boiler rooms, burners and engines are of particular interest. In this context, the infrared (IR) and UV
The project objective was to study the possibilities for new and cheaper methods of generating ozone by means of different types of micro-plasma generators: DBD, MHCD and CPED. This project
The project developed a computer method for quantifying wind turbine structural loads caused by fault ride-through (FRT) requirements. Exemplified in the case of an active stall wind turbine this
The project studies two issues in distribution systems 1)Normal Operation Optimization models the load optimal response to electricity price, power system constraint impacts. 2)Control Strategies in
The project objective was to optimise an LT PEM-based ìCHP and UPS system. Both IRD and Dantherm obtained significant project results. The project results regarding MEA performance, lifetime and stack
MEAs constitute the costliest key component and are also crucial to performance and lifetime of the total system. The project focused on developing basic materials and technologies for MEA improvement
The objective of the project was to study new deNOx catalysts with improved alkali resistance in relation to flue gas from biomass-fired facilities. Alkali resistance of three types of catalysts is so
Experimental investigations were conducted on two identical small-scale SI gas engine generator sets operating on biomass-produced gas from thermal wood gasification. The engines operated with two
The project evaluated the benefit of compressed air energy storage (CAES) in a Danish system, where wind power accounts for 20% of consumption and CHP for 50%. The project starting point was energy