The project objective is to mature the HT-PEM fuel cells (RMFC technology), which use reformed methanol. The project shall, among other things, reduce emissions and prove the efficiency of the system
The purpose of the project is to introduce and implement a new dynamic data analysis method, DDA, in the Danish wind industry. This method is based on fast measured data rather than traditional 10min
In the following are show the different work packages. After each the timing and goals are shown: WP1 Screening test and optimization of basic parameters for efficient densification of torrefied
The scope of the project is to develop, design and construct a 1-kW direct methanol fuel cell (DMFC) unit for back-up power, auxiliary power and micro combined heat and power solutions, and to
The IEA-Task 37, Energy from biogas is an international partnership of knowledge transfer and research exchange, aiming to carry out expert technical work, expert technical support to policy makers
The purpose of the project is to strengthen the Danish contribution to the International Energy Agency project 'IEA Annex 30: Offshore Comparison of Dynamic Computer Codes and Models' with an
The aim of the project is to participate in IEA Hydrogen Implementing Agreement (HIA), in order to stimulate hydrogen R&D activities in Denmark and to co-ordinate Danish and international scientific
The main objective of this project was to prepare the first ever REnescience commercial scale demonstration plant to be ready for operation before 2013.
New energy technologies enabling replacement of fossil fuels must be developed during the next decades. Gasification has been identified is an important contribution. This technology is expected to
The project has resulted in the development of a 10 kW fuel cell system called H2Drive (R) for vehicles for material handling vehicles. H2Drive (R) containing fuel cell and battery pack, and can
The plan is to develop a PEM (Proton Exchange Membrane) fuel cell stack with integrated basic functionality for micro combined heat and power. Balance of plant components are integrated into the fuel
The purpose of the projekct is to duce cost of energy in the design, production, transport, installation and maintenance of monopile foundations for large offshore wind turbines. The primary goal is
The present application comprises co-funding of the IRD participation in the KeePEMAlive FC JTI project that presently is under negotiation for start primo 2010. The overall objective of the
The main objective of the DuRaPEM project is to further develop pathways and technologies for PEM FCs enabling the national target lifetimes to be met. The project approach is systematically to
The purpose is to clarify advantages and disadvantages of a large biogas grid supplying larger customers. The biogas grid will be connected to the natural gas grid. Some involved subjects are
The purpose of the project is to improve and validate newly developed models for simulation and prediction of wind power fluctuations, by integrating the tools with meteorological tools for wind
The main purpose of the project is the development of SO3 in-situ IR measurement technique which will be suitable for industrial applications on SCR units of power plants and proved on an industrial
The solid oxide fuel cell (SOFC) is an attractive technology for the generation of electricity with high efficiency and low emissions. This project will improve the power density, durability, and
The aim of project is to investigate the combination of biomass gasification with SOFC in an efficient decentralized and flexible energy system for small scale combined heat and power production. The