Traditional Comressed Air Energy Storage (CAES) is seen as one of the most cost effective technologies for the bulk energy storage in the future flexible grid. The project will investigate the
The project will evaluate the potential of reducing harm caused by emission from gas fired engine based CHP plants. This is done by combining measurements on engines at different engine setting with
This project seeks to demonstrate the methane reduction at gas engine CHP plants is possibel with technology previosly used on large dual fuel engines. Methane emission from gas engines raise the
This project will identify and analyze the primary causes for formation particles in exhaust gas from gas engines at CHP plants. The project will be performed in close co-operation with manufacturers
Based on the results achieved in Phase 1 and 2 (the practical experiments and theoretical calculations of a 5x5 m energy membrane), this project shall further clarify and assess the technical and
The aim of the work is to participate in the IEA Hydrogen Implementing Agreement (HIA), in order to stimulate and co-ordinate hydrogen activities in Denmark.
The main activity is semi-annual workshops focusing on presentations of model analyses and use of the ETSAP' tools (the MARKAL/TIMES family of models).
Under the IEA-ETDE (Energy Technology Data Exchange) agreement a common database is produced containing descriptions of journal articles, reports, books, conference papers etc. published in the member
The partnership evaluated up-to-date knowledge in the area. Against this background, method guidelines will be prepared for assessing costs and advantages of integrating large wind energy shares in
The project objective was to undertake a screening of commercial natural gas reformers to be used in combi-nation with low temperature PEM fuel cells in the power range 2-3 kWe.
The project built on the results of a 2001 hydrogen project which focused on hydrogen as an energy carrier in a purely Danish system. The perspectives of this project were extended to include the
The project was focused on the development of new design methods for wind turbine blades, so that uncertainties associated with damage and defects can be reduced.
The overall aim of the project was to determine what effect the energy policy introduced through the law on CO2-quotas would have on the development the energy sector in Denmark.
The aim is to make information about Danish energy research and its results available to users in Denmark and abroad and, through international co-operation, to make international research and its
The aim of the project is to elaborate and disseminate knowledge about the development of the heat supply of residential areas in the future in terms of the changed conditions.
The study contaiins a review of the current sorption gas fired heat pumps for residential space heating and also the visible development trends. A prototypw heat pump has been laboratory tested.