The aim of this project is to design, test, optimize and prepare for an industrial scale demonstration of microwave cracking technology, converting biomass to biofuels and biochar for carbon storage
The primary objective of the project is to address the pressing issue of methane emissions in the biogas sector by developing and implementing an innovative methane detection drone and measurement
Efforts to change road transport is focused on electrifying the transport sector. The main disadvantages of this strategy are that it requires replacing the existing vehicle fleet and an entirely new
The main purpose of this project is to develop and demonstrate an optimized heating plant that will have much higher efficiency and much less CO2 emissions than the heating plants that are built today
HydroThermal Liquefaction (HTL) has proven itself as the most resource-, energy- and cost efficient technology pathway for conversion to liquid fuels of a wide range of sustainable feedstocks
The purpose is to develop a sustainable, operational and commercially viable biofuel to replace currently used fossil-based fuels in the maritime sector. Developments are based on patented.
The aim of the project is to develop ensiling as a method for pretreatment of straw which allows use in biogas plants and ensures a higher biogas yield. Wet or moist straw is treated with ’ensiling
Biowaste2Gas’ laboratory scale model is upscaled to a pilot plant. Following the initial testing, the plant is moved to demo-site for lifetime testing. In parallel, AU documents the potential in
InjectMe develops a biological Power-to-Methane technology that uses electricity and CO2 from biogas to produce biomethane (electrofuel). The aim of InjectMe is to develop a cost-efficient system for
Demonstrating that the effect of using pre-treated low valuable biomasses is an improved capacity of any given biogas plant by demonstrating that the pre-treatment provides the same amount of
AMMONOX focuses on developing a sustainable and economically attractive, ammonia-based process for a) enhancing the productivity of biogas plants based on manure, b) minimizing NOx emissions from gas
Loss of methane from biogas plants has detrimental environmental effects and reduces the efficiency and economic output of the biogas production. The aim of this project is to reduce the methane loss
This project proposes a bioenergy concept in which cast seaweed collected from beaches will be used as substrate in co-digestion with manure and other wastes in biogas plants for energy production
The vision of the present project is an online Predictive Corrosion Monitoring System (PCMS) that through measurements of few, significant flue gas components can predict and hence optimise the
This project identifies the economic and technical potential and barriers for increased power production and reduced loss of heat on district heat production by means of reduced temperatures and local
In order to reduce emission of the green-house gas CO2, power plants shall increase the use of biomass as fuel in the future. This challenges, however, the flue gas cleaning for the environmentally