Building on the results achieved in a first EUDP project, the purpose of this project is to finalise the development and testing of the technologies needed to produce extra – tall 3D printed wind
Power Curve, the Technical University of Denmark and Statkraft collaborate in order to develop a trailing edge serration product for wind turbine blades that offers increased noise reduction fea-tures
The purpose of the Thunderbolt project is to be able to deliver a fully commercialized service on subscription to the wind energy market after successful project execution, making it possible to
The project is dedicated to enhancing the efficiency and cost-effectiveness of foundation design for offshore structures such as windfarms and energy islands. The envisioned solution involves the
The project allows Floating Power Plant (FPP) to optimise and further develop novel floating wind concepts. The output will be three large demonstration activities and six innovations, including a
Silver's use in PV cell metallization is contributing to a future silver shortage, hence necessitating a shift towards alternatives like copper. However, copper plating presents challenges including
Aeromine is a novel, building integrated windenergy system intended to compete with or supplement industrial rooftop solar PV. The EUDP project will improve the understanding of- and demonstrate how
Formålet med projektet er, at have mere pålidelige WTG-vinger i drift med forlænget levetid, sænke OPEX og optimere AEP, gennem anvendelsen af en risikobaseret tilgang. Hvis vingerne kan forblive i
In the work concerning experimental verification of thick airfoils, the focus has been on airfoils used by the industry. The method has been verified with measurements on a NACA 63-215 airfoil
The project objective is to develop more generally applicable assessment and design criteria for isolated power supply systems, and the expected result is a guideline for design of such systems.
The purpose of the project was to investigate how the rotor design of an existing wind turbine can be extrapolated to a 4 MW turbine. Within the project two optimization codes for optimizing a large
Transfer of technology and industrial cooperation require a common framework, thus a compilation and analysis of Russian wind load and other external conditions in relation to European wind turbine
The project constitutes a continously running 5 years research programme on aeroelasticity with the objectives to improve the basis for design and optimization of wind turbines, and establish an
IRD A/S has developed and tested a new high efficient grid connected DC/AC inverter concept for household, small scale photovoltaic power supplies for households etc. The inverter concept has been
The purpose of the project is to develop and test micrometeorological tools for the prediction and estimation of properties of the wind that are important for loads on wind turbines situated on land
The purpose of the project is to perform an experimental investigation of extreme load on wind turbines, measuring both the wind field and the structural load response on high wind speed sites.
The aim of the project is to develop and test a sensor for registering lightning strikes to wind turbines to be included in the general survillance and control systems of modern wind turbines.