The annex will give the participants an overview of the technical and environmental assessment challenges encountered in offshore applications and help them to understand the areas of further R and D
The project included the second phase of a process aimed at establishing a platform for wind turbine simulation as a prerequisite for advanced electrical design and optimisation.
The aim of the project is to develop, verify and implement a detailed physical model for the wind field in a wind farm. The model will allow for detailed aeroelastic simulation of wind turbines sited
The overall objective of the project is to ensure the development of an aetoelastic design complex, which can create the basis for the nest generation of wind turbines and make new design trends
This project, HAVDIM2004, aimed primarily at analysing already accessible measurement data from the two Danish offshore wind farms Horns Rev 1 and Nysted Offshore Wind Farm. The project focused on
The project generated results in selected areas of flexible multibody wind turbine modelling. Monte Carlo statistical response simulations and failure probabilities require significantly reduced
In DTU's and LM Wind Power's wind tunnel, the project performed several measurements of the flow behind vortex generators (VG). The project proved that the induced vortices effectively counteract
The project aimed substantially to strenghten the scientific basis for the wind turbine sector in general with particular focus on the Danish sector’s position in offshore wind farms. To meet these
This project demonstrated that further improvement and automation of wind power predictions within a 48-hour horizon is possible if the underlying tools such as WPPT (Wind Power Prediction Tool)
The object of this project was to show the existence of high-frequency fluctuations. The measurement of these fluctuations and the subsequent frequency analyses revealed that these frequencies may be
The object was to improve existing PARK models for calculating array losses for wind farms with focus on large offshore wind farms. The project shows that intelligent use of the model parameters
The compiled measuring results and modelling tests produced a scientifically founded basis for providing recommendations for future offshore wind farms in respect of mutual distances between farms and
The project establishes a new model of the Danish electricity system in the form of two buses (east and west Denmark), to which new models of load and production units are connected in the form of
The main goals of the simulation platform can be summarized as follows: 1) To extend the ability of the existing wind turbine design tools to simulate the dynamic behavior of the wind turbines and the
The objective of the project was an improved design base for extreme loads and fatigue loads on wind turbine in flat or mountainous terrain. The main activity was the development of models for non
The aim of the project is to develop better design basis for large wind turbine blade of composite materials by a combination of materials research, structural mechanics, involving both modelling and
The main objectives are the following: a) development of a design tool for analysis of dynamic stability. b) investigations of blade tip aerodynamics and blade tip design on basis of 3D CFD
This pre-project had the aim of establishing the basic technical knowledge to evaluate whether remote surveillance of the rotor blades of large off-shore wind turbines has technical and economical