The main purpose of the planned Phase III (PVIB-III) is establishment of 1,5 – 2 MW of additional capacity primarily in terms of a large utility scale PV power plant of at least 1,5 MW. Thus very
This project focuses on the integration of photovoltaics (PVs) with thermoelectric generators (TEGs) and microchannel heat exchangers (µHX) in two parallel phases: low-thickness solar power systems
MeGA-stoRE is a Power-to-Gas concept for producing methane from CO2. By operating on electricity, the system enables storage of considerable amounts of RE-resources from the electricity grid as
Electrochaea is developing an efficient and robust biological process to store low-cost electricity as renewable gas in the existing natural gas infrastructure. The P2G-BioCat project will allow us to
The scope of PV GRID is to address the large potential for stimulating commercial investment in PV in DK. The project purpose is to address identified barriers and assign possible solutions. A central
Danmarks Tekniske Universitet (DTU)
ForskEL
2012
2014
The purpose is to achieve an energy pay-back time of less than one year for a complete grid-connected installation with polymer solar cells. The project comprises development of polymer solar modules
Torrefaction is considered worldwide as a promising key technology for boosting large-scale implementation of bioenergy. It involves heating biomass in the absence of oxygen to a temperature of 200 to
Through dynamical plant simulation and demonstration of primary control (frequency reserves) from WtE plants to the power grid is investigated from a plant techno-economic point of view. The goal is
Aalborg Universitet (Fredrik Bajers Vej)
ForskEL
2012
2015
The 2stageBiogas project will increase efficiency of the biological conversion of organic waste into biogas for combined heat and power production. The focus will be on the improvement of the
Gas from biomass gasifiers contains both dust and tars, and both components are serious challenges for the downstream equipment as gasturbines and catalytic reactors. This project will test
Based on the Stirling engine technology the goal is to demonstrate how small scale RE based CHP plants can be the solution for many small and medium sized companies to reach a more green production
The purpose of the project is to improve the understanding of dioxin formation i WtE-boilers. The project will e.g. include investigation of the possibilities to reduce the part of ash with high
The project has focus on spectroscopy analysis of low-molecular-weight trace gases important in biomass gasification and combustion (e.g. sulphur, PAH’s, chlorine compounds). The purpose of the
The aim of the Catchcrop2biogas project is to investigate the potential of using catch crops as feedstock for biogas production. This will be done by screening 12 different catch crops samples
Extrusion as a pretreatment of dry biomasses, including deep litter and straw, to increase methane productivity in biogas reactors will be developed and optimised at a biogas plant. A pilot scale
This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure
The aim of the project is to make a final energy optimization of an air staged downdraft gasification plant by measures that reduce the output of charcoal and the consequently energy loss from the
The aim of the project is to ensure a technical and economical strong commencement of the operation of a complete entire CHP biomass gasification plant. The additional feed in tariff from the ForskVE
Denmark has a large untapped potential in biogas. Biogas is a cheap renewable energy source that helps to bring down CO2 emissions and increases Denmark’s independence in energy supply. Biogas
The purpose of the project is to analyse high efficiency bio-SNG production technologies, potential available biomass and different aspects of the interaction between the bio-SNG gases and the natural