As international shipping is a significant greenhouse gas emitter - if counted as a country, it would be on a ca. sixth place of energy-related CO2 emissions - the international maritime organization
The eWorkVehiclePower project develops and demonstrates a modular and scalable concept for flexible, cost-competitive and energy efficient electrical powering of professional working vehicles
The project is on membrane-based fuel cell systems using methanol as a ftuel and converting it to electricity with very high (45%) efficiency. The fuel cells and the plates connecting them in a stack
The purpose of the project is to gain access to low priced green hydrogen based on renewable electricity is of key importance for realising the transition to a fossil free energy system.
The purpose of this project is to…
1) design, build and demonstrate a high temperature fuel cell system for green fuels with an effi-ciency more than 40 % higher than state-of-the-art gensets for
The scope of the project is to develop and test an injector technology that will enable the use of alternative fuels in combination with conventional diesel fuel oils. The combustion of methanol and
Goal: To demonstrate the performance of a fuel cell bus in Copenhagen. Programme/Plan: When the bus is constructed, it will go into service in Berlin and then Copenhagen.
A 20 Nm2 Hydrogen storage has been specified to be used in a Ford Focus equipped with an internal combustion engine. The storage is constructed from commercial available metal hydrides.
The objectives of the project were to develop and manufacture a lightweight storage for hydrogen usable for pressures up to 300 bar and based on fibre reinforced tanks. Three storages have been
The objectives of the project have been to design and construct a PEM fuel cell driven car, which can be used for demonstration of hydrogen as a fuel in the transport sector. The project has been
The project is divided into two parts, i.e. a general review part and a project specific part. General: 1) General review of safety aspects related to hydrogen driven vehicles and related stationary
A method has been established for production of the anode supported thin-electrolyte cell. The anode supportis 200mum thick and made of NiO and TZ3Y by tapecasting. The electrochemically active anode
The main purpose of the present project has been to test a new type of MCFC unit developed in previous phases of the project. Various parts of the plant e.g. MCFC stack, reformer, catalytic burner