The main purpose of the IEA SHC Task is to demonstrate the possibilities regarding deep energy renovation of historic buildings in achieving the lowest possible enerdy demand and thereby CO2 emissions
The overall aim of the project is to develop and test the next generation of direct solar-powered coolers for storing vaccine and other temperature sensitive products such as fish and meat in areas
The purpose of this project is to develop better recommendations for understanding the solar energy resource in energy systems with high degree of renewable energy penetration. This is done as an
The long-term goals of OES Task 10 are:
1. To assess the accuracy and establish confidence in the use of numerical WEC models
2. To determine a range of validity of existing computational modelling
The objective is to continue Danish management of IEA SHC Task 57 ”Solar Standards and Certification” until the end of the task period. This task supports international co-operation on improvement and
The aim of the project is - through exchange of international knowledge - to develop and promote solar district heating plants. Denmark is in front in this field and the project gives good
The long-term goals of OES are:
1. To assess and establish confidence in the use of Wave Energy Converters
2. To engage and integrate Danish industry in international initiatives
3. To identify
The project is a part of the international cooperation on wawe power under IEA. The project will exchange information and experiences with wawe energy and asses ocean devices.
The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
The goal for this demonstration project to undergo an independent validation of wave energy machine "Rolling Upright" in the wave tank under controlled conditions, and in doing so have developed a
LEANCON Wave Energy
ForskVE
2012
2016
This ForskEL project will document the energy production of the wave energy converter MAWEC in real production mode. The overall project description is the same as in PSO project "Advanced Wave Energy
The purpose of the project is to design, build and test a 2 kW wave energy grid connected Lever Operated Pivoting Float LOPF buoy in the sea. The goal is to collect operational data on electric