Development of a stratifier, which when installed in an electrical heated water tank, can be used for: Moving electricity usage for heating electrical heated water tanks from peak load periods (e.g
The purpose of the project is to analyse and develop advanced filter solutions based on combinations of passive filters and active filters in wind power plants. The use of passive filters is almost
LED lighting includes a huge potential for energy saving. Substantial variation in quality for LED sources might destroy consumer confidence and delay the market penetration. In 2010, an IEA co
Light Extraction improves the efficiency of LED. Our method is based on industrially reproducible nanostructures that are more efficient than the microsized structures the industry uses today. The
D-Light will develop light sources based on diode lasers and demonstrate application of these light sources in lamp posts. Light sources based on diode lasers have the potential of being significantly
The objective is to develop a hybrid power pack for ground utility vehicles at the Copenhagen Airports, which both improves fuel efficiency and reduces the emission for ultra-fine particles at the
The behavior and movements of occupants has large effects on both indoor environment and energy consumption in buildings. This is not taken into consideration in the design of new or retrofits of
The project aims to develop, test and demonstrate electric heater to be fitted to existing residential gas installations as a means of providing additional flexibility to the power system.
A business
The project ” Multi-level medium voltage” converter is a development and demonstration project, which by proposing at new design aims at optimizing one of the most important subsystems in a wind
The purpose is testing and optimising large electric HPs (app. 5 MJ/s) using natural refrigerants, as well as testing both high and low temperature heat sources in the form of geothermal and sea and
The project objective is to design and test new coherent indoor climate and energy management systems in school buildings. The project is based on development of new functional standards and operation
To learn how to build the hybrid UHPC tower in praxis and prepare the technology for commercialization. Further development to up-scale the towers to larger heights, to make the towers entirely from
Task 35 will focus on wind turbine blade and drive train testing and assess their performance and failure criteria in different operating scenarios. The subtasks are: l) Relevant wind turbine
Our objective is to demonstrate an efficient, rugged, low-cost lidar for wind turbine blade pitch control. The new sensor will monitor the wind in front of the turbine using 4 lines-of-sight. This
The purpose of the project is to investigate the future testing strategies for the leading wind turbine manufacturer, to design, develop, assemble and demonstrate the future testing facility to
The objective is to test and demonstrate technically a real smart grid case with limited power capacity on a single radial, mix load and charging of several EV's. The case is selected such that the
The aim is to develop solutions that include holistic exergy principles applied on a community level. Different types of supply systems require different supply temperatures. To obtain the maximum
For energy efficient buildings or districts to reach their full potential, the issue of integrating energy storage and optimising its operation must be properly addressed. Therefore, there is a need