The objective of this project is to develop, design, build, test, optimize and commission FPPs first full-scale wave PTO system. The resulting PTO design will be used to build four identical PTO units
The first purpose is to optimize and demonstrate Exowave wave energy concept in a coastal offshore environment, where the produced seawater under high pressure is led ashore and converted to fresh
The Ocean Energy Systems (OES) Task 10, Part II continues the work on verification and validation of numerical models of Wave Energy Converters (WECs) previously supported by EUDPJ.nr. 64017-05197.
The aim of the PlateCell project is to develop and demonstrate roll-2-roll electrodeposition of thin film photovoltaics based on the earth-abundant and non-toxic, CZTS, semiconductor with at least 8%
The project will be the Danish part of the recently started IEA (International Energy Agency) SHC (Solar Heating & Cooling Programme) Task 64 on Solar Process Heat. The key components of solar heating
The project is a part of the international cooperation on wawe power under IEA. The project will exchange information and experiences with wawe energy and asses ocean devices.
The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
The goal for this demonstration project to undergo an independent validation of wave energy machine "Rolling Upright" in the wave tank under controlled conditions, and in doing so have developed a
LEANCON Wave Energy
ForskVE
2012
2016
This ForskEL project will document the energy production of the wave energy converter MAWEC in real production mode. The overall project description is the same as in PSO project "Advanced Wave Energy