Electrical heat pumps have great potential to obtain the announced energy and climate goals. A heat pump of around 1 MW (heating) will be installed in Ans. The project aims at a quick installation
The project objective is to build and operate a scalable bioreactor to meet key goals of the Danish energy
strategy. The project will efficiently integrate renewable electricity from the power grid
The high level objective of this project is to analyze and extend the scope of lessons arising from early exemplar low-temperature district heating (supply temperature 50-55°C) schemes, in order to
The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
The overall objective is to enable the integration of larger amounts of distributed renewable energy sources (especially wind power) in the energy systems. The specific goal is to develop an
The project will demonstrate electricity regulation and reduction of the natural gas consumption on a natural gas fired CHP-plant. This is done by implementing a solar thermal plant in combination
The aim is to develop a compact seasonal heat storage based on a salt hydrate with stable supercooling. The heat storage can be part of a solar heating system which can fully cover the yearly heat
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
A concept for energy efficient control of air-air heat pumps and electric storage water heaters with focus on indoor clima, energy savings and demand response is developed. A plug n' play-solution for
The purpose of the project is to identify limitations of existing simulation and planning tools for distribution grids, with a particular focus on the challenges imposed by the introduction of Smart
The goal of the project is to increase the efficiency and reduce emissions for engines operating on biogas and biomass producer gas. Engine operation will be characterised experimentally and
IHSMAG studies the integration of households in the smart grid and develops design recommendations. The Danish part focuses on how electric vehicles are integrated into the everyday life of households
The aim for the proposed project is to analyze and demonstrate the possibilities of utilizing environmental-friendly surplus power production for heat production. Developing and demonstration of the
The project will result in a concept for the information needed, when power consumers are to participate more actively in the power market by making their consumption flexible in time and dependent on
This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure