The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure
Eco-friendly production of plastic solar cells in Denmark. Plastic solar cells are almost capable of competing with commercial solar cells. The processing method has environmental consequences in
As a follow-up to PV Island Bornholm, Phase I project targeting implementation of 1 MWp of PV on the island of Bornholm, it is proposed to establish a phase II targeting an additional 1 MWp. The
In the proposed PV-Boost-2015 project coordinated by Gate 21 it is intended to realise 700 kWp innovative BIPV systems in zero energy and low energy class1 and 0 buildings in 7 dif-ferent cities in
The main purpose of the Solar City Horsens initiative and the EFP project of the same name, which started in 2004, was to create a counterpart in Jutland to the ongoing Solar City Copenhagen co
In accordance with the Danish national PV Strategy an investigation has been carried out to: 1) elucidate the connection - if any - between deployment of and prices for PV technology; 2) analyze the
The project is a research activity aiming to create new technology, reduce specific costs and improve efficiency. The project specifies an inverter concept, which forms the basis for developing
During training of two research students, the project developed new thermocleavable polymer materials for PV cells with a narrow optical band gap, allowing simple production of multilayer structures
An integrated PV cell–solar heating roof solution called PV Optitag was developed in close cooperation between architects and engineers to make new CO2 neutral solutions for urban development projects
The main purpose of PV Denmark is to continue and enhance the positive development initiated by previous national projects such as Sol-300, Sol-1000 and Sol-2000. The activities shall facilitate, that
GAIA SOLAR A/S
ForskEL
2006
2011
The project aims at developing a window solution, with integrated solar cells in the glazing, which is 30% cheaper than similar products on the market. Development and production of components is