This project will develop a novel inspection and interpretation technology for performing in-situ measurements of leading edge surface roughness (LER) and convert these measurements into normative
The overall objective of the project is to demonstrate the system integration, the functioning, the performance and the value of an active flap system by full scale turbine tests. A further objective
The project objective is to drive the novel foundation, known as the Mono Bucket, to full commercial readiness and contribute significantly to reducing costs of offshore wind energy by 30-40%. This
This open-access book aims at giving a clear overview of all the main technical and commercial aspects that are involved with the development of wave energy converters. The book will be written by
The lubricating system on a large two-stroke diesel engine consists of a unit that continually adds new oil to each cylinder. Unlike in a four-stroke engine the oil is only used once. Sorne of the
Effective thermal energy storage (TES, Thermal Energy Storage) will be used as a central technology in the flexible energy systems of the future where increasing part of the energy needs will be
The overall purpose of this project is to develop Medi Sander Wind and significantly reduce costs regarding blade production. The objective will be reached through a new patented technology. In
The objectives of the TrueWind project are to improve accuracy of cup anemometer measurements for wind resource assessment and power curve measurements by introduction of very short range lidar
The project´s objective is to build a theoretical knowledge about gyro electric energy conversion systems, particularly for use in connection with wave energy. The primary goal will be to develop a
Geothermal energy is a green, renewable source of energy with the potential to significantly alter the prevailing mix of energy sources. The project looks at how geothermal energy can be integrated
The vision of HiGradeGas is to overcome the barriers towards a wide-spread and
sustainable use of biogas in the Danish energy system by improving the cost
efficiency of (i) biogas upgrading and (ii)
FutureGas seeks to stimulate: an efficient and economical supply of gas - including gas based on renewable sources, an appropriate and flexible use of these gases, and an optimal integration of gas in
The target is to demonstrate the Floor as a structural enhancement technology on blades. This will overall reduce failure rates on blades and in the long run reduce the operation and maintenance cost
To design a new guiding system for installation of HVAC booster stations and cable handling concept that will make offshore wind parks more cost-efficient.
The purpose is to develop and demonstrate additive manufacturing methodes in the wind industry. The methods are in this project tested on a Vestas blade section (8 meter I-beam). The methods shall