Photovoltaic technology has a huge potential in a renewable energy system. Today, however, solar cells are expensive and not very efficient. THINC seeks to develop a new type of solar cells, using
Wind turbine components such as gears and naves are exposed to large and very dynamic loads. The typical modes of production have difficulties handling this. REWIND focuses on materials, processes
A major technical development is required if Danish heat and power plants are to replace fossil fuels with biomass in the future. GREEN will facilitate this development by optimizing the agricultural
Accumulation of excess hydrogen in the production of biogas from manure is a problem, because it slows down the process. HYCON investigates the influence and distribution of hydrogen in the conversion
Subterranean layers of sandstone can be an important storage of heat energy from renewbale energy sources by pumping down hot water. HEHO develops an integrated model for predicting how pumping down
Waste as a flexible energy source and wast recycling are important elements of a greener society. TOPWASTE will develop new and advance existing models for planning the treatment of waste, in part
Electronics that control and convert electricity (power electronics) is a cornerstone in our energy systems and the conversion to sustainable energy. CORPE seeks to develop tools for design of cheaper
Hydrogen from electrolysis is a reliable and clean medium for energy storage. However, the technology for electrolysis is inefficient and expensive. MEDLYS will develop and test efficient, cheap and
A future energy system based on sustainable energy requires flexible production, consumption and transmission of electricity. We are to make large investments in the infrastructure. ENSYMORA will
These years, Denmark is banking on green growth and innovation. However, our understanding of energy innovation systems is limited. EIS explores and analyses the dynamics of knowledge-sharing within
With the key performance criteria for the project in mind (dynamics and energy efficiency) the requirement specification for the 2nd generation Solar Array Simulator has been finalised.
Despite existing modern technologies about 70% of Danish oil resources are considered unrecoverable. Advanced biotechnology could improve oil recovery and reduce transport systems downtime.
Particle accelerators bring atomic particles close to the speed of light using high current electromagnets. The project aims to develop magnets that will significantly reduce power consumption.
The project aims to optimise existing solutions to the yaw mechanism for wind turbines, improve properties with regard to noise, fatigue and peak load, wear and service.
The project purpose is to develop advanced pro- cess technology that enables industrial produc- tion of environmentally friendly cement of high quality and with low CO2 emissions from locally
ALPCON A/S
ForskEL
2010
2011
The main purpose of the SOFTEG phase II project is to develop a high efficient TEG based on the TE material Zn4Sb3. The TEG will be integrated and tested in a Solid Oxide Fuel Cell (SOFC) micro
AMMONGAS A/S
ForskEL
2010
2011
The purpose of the project is to devellop, demonstrate and verify a cheap type of water/amin scrubbing method for removal of CO2. Leading to a gas so comperatible to natural gas, in respect to
The simulation model SmartGen will identify opportunities efficiently for DG based on SmartGrid-models. DK will develop SGT-models, e.g. production reg. for smaller CHPs, heat pumps, charger depots
Develop PV-optimised power products, for maximised economical yield of the PV generation. Describe how data from the electronic meters can be integrated into distribution and trading companies'