The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure
Eco-friendly production of plastic solar cells in Denmark. Plastic solar cells are almost capable of competing with commercial solar cells. The processing method has environmental consequences in
As a follow-up to PV Island Bornholm, Phase I project targeting implementation of 1 MWp of PV on the island of Bornholm, it is proposed to establish a phase II targeting an additional 1 MWp. The
In the proposed PV-Boost-2015 project coordinated by Gate 21 it is intended to realise 700 kWp innovative BIPV systems in zero energy and low energy class1 and 0 buildings in 7 dif-ferent cities in
SOLBY2006 Solar energy in the energy frame – phase 2. The purpose of phase 2 was to implement a number of development and demonstration projects of solar thermal and photovoltaics for low energy
Based on the development projects under the Photovoltaics & Architecture main project, a catalogue has been published of current photovoltaic integration in Danish buildings.
A calculation tool was developed for use of solar energy in renovation and new construction projects - BYG-SOL – for professional clients, local authorities, architects and consultants. The tool may
The focus on the Danish part of the IEA project SHC Task 32 Advanced Storage Concepts for Solar and Low Energy Buildings was on Subtask C: Storage Concepts Based on Phase Change Materials and on
The overall goal with the participation in IEA PVPS is to maintain and build upon the knowledge transfer to Denmark via the participation in the IEA PVPS work. By the participation a network is
The purpose of the project has been to examine the possibilities for PV in an industrialised building process. The project is an information gathering and development project with basis in knowledge
The project proved that PowerShade with an efficiency ratio in excess of 5% can be produced, and that future development will probably further increase its efficiency. The project also showed that the