The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure
Eco-friendly production of plastic solar cells in Denmark. Plastic solar cells are almost capable of competing with commercial solar cells. The processing method has environmental consequences in
As a follow-up to PV Island Bornholm, Phase I project targeting implementation of 1 MWp of PV on the island of Bornholm, it is proposed to establish a phase II targeting an additional 1 MWp. The
In the proposed PV-Boost-2015 project coordinated by Gate 21 it is intended to realise 700 kWp innovative BIPV systems in zero energy and low energy class1 and 0 buildings in 7 dif-ferent cities in
The aim of the project is to demonstrate a full scale pit heat storage (60.000 m3 ) in combination with a large solar collector field (35.000 m2) and heat pumps (3 MW).
The main goal was to improve solar architecture as well as better qualified architects and better communication and interaction between architects, engineers, manufacturers and clients.
MicroShades are window glass panes with built-in shading based on geometric screening of solar rays, shading direct solar irradiation from the outside while having a clear outlook from the inside. The
The use of air-conditioning in Denmark is strongly increasing. Most new office buildings are equipped with airconditioning plants. Furthermore the new building regulations means an increasing need for
The project wishes to develop and test season heat storage for solar heating plant based on a salt hydrate. A line of experimental and theoretical studies shall help define how the heat storage is
The project aims at developing and demonstrating a new fluent and isolated selling construction for the 10.000m3 water heating storage in Marstal Fjernvarme. The solution is expected to be implemented
The aim of the project is to measure the collector efficiency and investigate the state of a few old solar collectors for solar heating plants. The collectors, which will be investigated, have been in
This Solar Thermal Action Plan is a follow up on the Solar Thermal Strategy, which showed large potentials for utilization of solar thermal in Denmark. In the Action Plan it is shown how the ambitious