The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
This project aims to support the integration and higher penetration of PV systems into the electrical power systems by advanced grid condition monitoring and grid control, Diagnostics and failure
Eco-friendly production of plastic solar cells in Denmark. Plastic solar cells are almost capable of competing with commercial solar cells. The processing method has environmental consequences in
As a follow-up to PV Island Bornholm, Phase I project targeting implementation of 1 MWp of PV on the island of Bornholm, it is proposed to establish a phase II targeting an additional 1 MWp. The
In the proposed PV-Boost-2015 project coordinated by Gate 21 it is intended to realise 700 kWp innovative BIPV systems in zero energy and low energy class1 and 0 buildings in 7 dif-ferent cities in
The participants want to develop fully roof integrated solar collectors to fit all roof materials in shape and design. After development demonstration units should be made and tests to get approval
The IEA SHC Task 38 has developed and tested solar driven air-conditioning system for dwellings and stores. The task has developed concepts for small or medium sized systems, documented new pilot
Denmark has participated in the IEA PVPS activities since its inception in 1993. The Danish participation will be in the following tasks: ExCo, the steering committee of the work in the task and the
The project is an international IEA – project. The IEA team shall document the methods within system combinations between solar heat plants and heat pumps, which are the most popular technologies at
Large scale PV plants are increasingly established in EU countries, but so far not in Denmark. The project has described the advantages and disadvantages of large scale PV plants in Denmark. It has
The objective of the project is to promote the use of district heating driven adsorption heat pumps in Denmark. The goal is to ensure that the benefits of adsorption heat pumps, solar energy and
The purpose of the project is to develop demonstrate and document a new renovation concept for existing multi storey housing, reducing the energy demand to Low Energy Class 1. Results are disseminated
The goal was to investigate and demonstrate the abillity to store excess heat in the subsoil down to 100 m in so-called energy wells, and then use the accumulated heat via a heat pump during winter.