The object of this project was to show the existence of high-frequency fluctuations. The measurement of these fluctuations and the subsequent frequency analyses revealed that these frequencies may be
In this project a number of industrial and agricultural waste products have been characterised and evaluated in terms of alkali-getter performance. The intended use is for biomass-fired power stations
The object was to improve existing PARK models for calculating array losses for wind farms with focus on large offshore wind farms. The project shows that intelligent use of the model parameters
The compiled measuring results and modelling tests produced a scientifically founded basis for providing recommendations for future offshore wind farms in respect of mutual distances between farms and
Københavns Universitet
ForskEL
2004
2011
Recycling of nutrients in wood ash is currently made difficult by the Danish bio ash notice (2004). The aims of this project is to develop and compile a well-documented concept for recirculation of
The project establishes a new model of the Danish electricity system in the form of two buses (east and west Denmark), to which new models of load and production units are connected in the form of
The project aimed at developing additives that will minimise corrosion during biomass combustion. To determine the impact of additives on SCR catalysts, the project tested potential additives in the
The project is published as a ph.d. thesis. The thesis analyses the possible relationship between lifestyle and energy use. The concept of lifestyle has become a key word in understanding the impact
The present continuation of the project 2 Generation solar walls is convering the work in an iterative process, with simulation, results analysis and programme study being the main elements. Thus, it
One main objective has been to co-ordinate the Danish activities within the IEA Bioenergy Agreement. Another international activity has been then chairmanship in the bioenergy processes/photosynthesis
Goal: To demonstrate the performance of a fuel cell bus in Copenhagen. Programme/Plan: When the bus is constructed, it will go into service in Berlin and then Copenhagen.
A 20 Nm2 Hydrogen storage has been specified to be used in a Ford Focus equipped with an internal combustion engine. The storage is constructed from commercial available metal hydrides.
The objectives of the project were to develop and manufacture a lightweight storage for hydrogen usable for pressures up to 300 bar and based on fibre reinforced tanks. Three storages have been
The objectives of the project have been to design and construct a PEM fuel cell driven car, which can be used for demonstration of hydrogen as a fuel in the transport sector. The project has been
The purpose of this project is to measure the reactivity of char from biomass (straw) during gasification. Especially catalytic effects will be examined.
The project is finished with the book 'Foresight' describing the paramount changes following the increased capacity of computers, reduced size, web connectivity, mobility and improved performance
De Nationale Geologiske Undersøgelser for Danmark og Grønland
EFP
1998
2000
The aim of the project is to improve the knowledge of flow mechanisms in fractured chalk reservoirs, and to improve the simulation tools for studying such reservoirs. Water injection in fractured
The goal of the project is 1.Study/test the performance of a prototype flywheel rotor for kinetic energy storage systems, developed and manufactured in a previous program, and 2. Perform feasibility