The objective of the project is to contribute to the development and implementation of industrial heat pumps of the future. That will take place by participating in a newly established annex under the
Admixing of alcohols in motor fuels can result in CO2 reductions and even better combustion, but also holds a number of technical challenges. The International Energy Agency wished to create a global
The project will compare next generation biodiesel to current biodiesel. HVO Biodiesel has superior properties compared to the traditional FAME type biodiesel produced by DAKA and Emmelev.
The project focuses on improving the gas yield from animal manure, straw and degassed fiber residues by pre-treatment. The objective is to demonstrate process stability during continuous pilot plant
RETROMAX aims to develop and demonstrate a slurry treatment technology that economically increases the amount of animal slurry/manure based feedstock to biogas plants resulting in a higher biogas
The project aims at testing the Pyroneer technology as a promising platform for improved utilization of a variety of low-value and difficult fuels from different sectors in society in order to produce
Topsoe's new methanol reactor (CONRAD) produces syngas and methanol from biomass. The project will demonstrate that CONRAD works as expected at industrial conditions and investigate how this novel
The purpose of the project is to create a sustainable systemic energy concept based on local CO2 neutral energy sources by integrating biomass based technologies and optimizing the energy flows
The goal of the project is to demonstrate a fuel cell based utility vehicle for indoor and outdoor service operations. This is linked to the clear benefits accociated with the implementation of fuel
Measurements on new and especially nearly-zero energy buildings have revealed that the energy demand often is much higher than calculated in the design phase. There is thus a need for development of
Continuing participation in international cooperation in IEA working group: ''Energy Conservation in Building and Community Systems'' ECBCS Annex 54: Micro-generation deployment in buildings. Prepare
The project aims at giving Denmark influence on the international requirements and standards for new energy-saving LED (Light Emitting Diode)-based lighting products and at ensuring that Danish
The project aims to develop and demonstrate a suction arm for process extraction based on automation and robotics technology that follows the pollution from industrial processes with lower energy
Industrial scale heat pumps have until recently been limited to maximum temperatures of 75 - 80°C and thereby limiting the implementation of high temperature heat pumps. The hybrid heat pump combines
The aim is to create cooling based on MVE. Progress: 1. Modification of MVE; 2. Elucidation of operational state. Development of: 3. Mixing module; 4. Controlling algorithm; 5. Regulating mechanism; 6
The project aims to demonstrate how intelligent LED (Light Emitting Diodes) street lighting with integrated intelligent traffic sensor for activity and traffic detection can be integrated with the
The project will develop and demonstrate a new revolutionary chiller which only uses water as refrigerant. The project will develop the technology from the laboratory level to turn-key field test
The opbjective of the project is to realize the most intelligent high-end platform seen on the market today for autonomous solar energy powered lighting application. An interactive dimensioning tool
Decanter centrifuges are used at waste water treatment plants for separating water from sludge. Our objective is in this project to establish and test a new energy efficient decanter control system