Admixing of alcohols in motor fuels can result in CO2 reductions and even better combustion, but also holds a number of technical challenges. The International Energy Agency wished to create a global
The project will compare next generation biodiesel to current biodiesel. HVO Biodiesel has superior properties compared to the traditional FAME type biodiesel produced by DAKA and Emmelev.
The project focuses on improving the gas yield from animal manure, straw and degassed fiber residues by pre-treatment. The objective is to demonstrate process stability during continuous pilot plant
RETROMAX aims to develop and demonstrate a slurry treatment technology that economically increases the amount of animal slurry/manure based feedstock to biogas plants resulting in a higher biogas
The project aims at testing the Pyroneer technology as a promising platform for improved utilization of a variety of low-value and difficult fuels from different sectors in society in order to produce
Topsoe's new methanol reactor (CONRAD) produces syngas and methanol from biomass. The project will demonstrate that CONRAD works as expected at industrial conditions and investigate how this novel
The purpose of the project is to create a sustainable systemic energy concept based on local CO2 neutral energy sources by integrating biomass based technologies and optimizing the energy flows
The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
The aim of lEA Bioenergy Task 37 is the international collaboration and mutual exchange of research, knowledge and information between the member countries, in the area of production and utilisation
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the
The objective is to develop a system that permits a diesel engine to run on bio-ethanol with high efficiency and low emissions. R&D in system components, catalyst as well as fuel injection and engine
The project develops and demonstrates a new biogas infrastructure consisting of 35 km biogas grid, connectiong 5 farm biogas plants with Skjern Power Supply. This is the first stage in ''Ringkøbing
ComBigaS will develop a biogas plant where the slurry is being produced so the flow of energy is being minimized. The systems are developed with an eye to the standardization and thus facilitate makes
Transform energy consuming commercial greenhouses into solar energy production units with lightweight solar absorbers interconnected and serviced by an electrical heat pump.
The objective of the project 'Industrialisation of polymer solar cells' is to establish low-cost, massproduction of solar cells in Denmark, and furthermore to demonstrate the potential of polymer
Based on the Stirling engine technology the goal is to demonstrate how small scale RE based CHP plants can be the solution for many small and medium sized companies to reach a more green production
The purpose of the project is to improve the understanding of dioxin formation i WtE-boilers. The project will e.g. include investigation of the possibilities to reduce the part of ash with high