Building on the results achieved in a first EUDP project, the purpose of this project is to finalise the development and testing of the technologies needed to produce extra – tall 3D printed wind
The aim of this project is to design, test, optimize and prepare for an industrial scale demonstration of microwave cracking technology, converting biomass to biofuels and biochar for carbon storage
Power Curve, the Technical University of Denmark and Statkraft collaborate in order to develop a trailing edge serration product for wind turbine blades that offers increased noise reduction fea-tures
The purpose of the Thunderbolt project is to be able to deliver a fully commercialized service on subscription to the wind energy market after successful project execution, making it possible to
The project is dedicated to enhancing the efficiency and cost-effectiveness of foundation design for offshore structures such as windfarms and energy islands. The envisioned solution involves the
The project allows Floating Power Plant (FPP) to optimise and further develop novel floating wind concepts. The output will be three large demonstration activities and six innovations, including a
Aeromine is a novel, building integrated windenergy system intended to compete with or supplement industrial rooftop solar PV. The EUDP project will improve the understanding of- and demonstrate how
The primary objective of the project is to address the pressing issue of methane emissions in the biogas sector by developing and implementing an innovative methane detection drone and measurement
Formålet med projektet er, at have mere pålidelige WTG-vinger i drift med forlænget levetid, sænke OPEX og optimere AEP, gennem anvendelsen af en risikobaseret tilgang. Hvis vingerne kan forblive i
The main goals of the simulation platform can be summarized as follows: 1) To extend the ability of the existing wind turbine design tools to simulate the dynamic behavior of the wind turbines and the
The aim of the project was to test the recently developed VFA online sensor under long-term operation at a large-scale biogas plant (Lintrup). The goal was to identify requirements of the system for
A model of a updraft gasifier was established. Problems about solving the system of equations was realized. Experimental results about heating up and pyrolising wood chips was created.
The project has included the Danish Representation in the Technical Committee for biomass Utilisation, task 32, Biomass Combustion and Cofiring during 2001. The Activity is referring to the IEA
The main objective is to achieve higher combustion efficiencies and lower environmental impacts of biofuelled boilers by improving process control to take into account variations of the moisture
The objective of the IEA task is to synthesise and transfer to stakeholders important knowledge and new technical information concerning conventional forestry systems for sustainable production of
The main objectives of IEA Task 38 Greenhouse Gas Balances of Biomass and Bioenergy Systems are to calculate, analyse and assess the effects and impacts on greenhouse gas emissions of (1) substitution
The political and technical objective of the project is to ensure an efficient outcome of the Danish participation in the international work group IEA Bioenergy Agreement, Thermal Gasification of
The long-term objective of the project is to improve the energy efficiency and to increase the annual operating hours for furnaces for waste and/or biomass combustion. The project objective is