The objective of the project is to contribute to the development and implementation of industrial heat pumps of the future. That will take place by participating in a newly established annex under the
The goal of the project is to demonstrate a fuel cell based utility vehicle for indoor and outdoor service operations. This is linked to the clear benefits accociated with the implementation of fuel
Measurements on new and especially nearly-zero energy buildings have revealed that the energy demand often is much higher than calculated in the design phase. There is thus a need for development of
Continuing participation in international cooperation in IEA working group: ''Energy Conservation in Building and Community Systems'' ECBCS Annex 54: Micro-generation deployment in buildings. Prepare
The project aims at giving Denmark influence on the international requirements and standards for new energy-saving LED (Light Emitting Diode)-based lighting products and at ensuring that Danish
The project aims to develop and demonstrate a suction arm for process extraction based on automation and robotics technology that follows the pollution from industrial processes with lower energy
Industrial scale heat pumps have until recently been limited to maximum temperatures of 75 - 80°C and thereby limiting the implementation of high temperature heat pumps. The hybrid heat pump combines
The aim is to create cooling based on MVE. Progress: 1. Modification of MVE; 2. Elucidation of operational state. Development of: 3. Mixing module; 4. Controlling algorithm; 5. Regulating mechanism; 6
The project aims to demonstrate how intelligent LED (Light Emitting Diodes) street lighting with integrated intelligent traffic sensor for activity and traffic detection can be integrated with the
The project will develop and demonstrate a new revolutionary chiller which only uses water as refrigerant. The project will develop the technology from the laboratory level to turn-key field test
The opbjective of the project is to realize the most intelligent high-end platform seen on the market today for autonomous solar energy powered lighting application. An interactive dimensioning tool
Decanter centrifuges are used at waste water treatment plants for separating water from sludge. Our objective is in this project to establish and test a new energy efficient decanter control system
The goal of the project is to build intelligent control into photovoltaic (PV) panels to allow for an automatic evaluation of the panel performance in order to bypass panels or section of panels e.g
The project aims to develop a stable bearing solution for the turbine in the air conditioner AC-Sun with a sealing device preventing mixing of the steam flow in the turbine and compressor circuit. The
The purpose of this project is to investigate the technical and commercial potential of a new method to purify raw silicon (Metallurgical Grade silicon or just MG-Si). The fundamental concept for a
Development of wireless communication based on Tag and Trace solutions, which must contribute to optimise the interaction between energy management, maintainess and resource use at the Hospital Unit
It is agreed to realise a EUDP supported project aimed at development, test and documentation of ''Solar Energy Roofs for Energy Renovation'', where there is a special focus on how to obtain the